4 Revision History
Changes from Revision C (October 2020) to Revision D (June 2022)
- 更改了數據表標題Go
- 通篇將英文的“wake up”（喚醒）更改為“wake-up”（喚醒）Go
- Changed description of the OSCI (pin 1) and OSC2 (pin 2) in the
Pin Functions tableGo
- Added a second paragraph to the OSC1 and OSC2 Pins
sectionGo
- Changed register Timestamp Prescalar to: Timestamp
Prescaler
Go
- Changed bit 23 from: RSVD to: SMS in Table 8-20
Go
- Changed bit 9 description from: Transmission Completed to:
Transmission Cancellation FinishedGo
- Changed bit 32:24 to: 30:24 in Table 8-56
Go
- Changed bullet: This is where the termination is split into two
resistors, R5 and R6 To: This is where the termination is split into two
resistors, R4 and R5 in the Layout Guidelines
Go
- Added bullet for R8 in the Layout Guidelines
Go
- Changed the Layout Example: added resistor R8 to Pin
1.Go
Changes from Revision B (November 2019) to Revision C (October 2020)
- Changed UVSUP rising max from 5.9 to 5.7 and added min value
of 5.2Go
- Added UVSUP falling max value of 5.0Go
- Changed bit 2:0 To: 3:0 in Table 8-29
Go
Changes from Revision A (April 2019) to Revision B (November 2019)
- 添加了“功能安全質量管理型”首頁項目符號Go
- Changed VIO value IIL for SDI, SCK and nCS inputs
in test conditions cell value from 0 V to 5.25 VGo
- Changed Power Up Timing diagram VSUP ramp voltage level for INH turn on and timing.Go
- Added INH Brownout Behavior section in Application section.Go
Changes from Revision * (October 2017) to Revision A (April 2019)
- 將文檔狀態從預告信息 更改為量產 數據Go
- Changed footnote Gauranteed to Specied throughout the electric
table.Go
- Added VIO values for tSOV.Go
- Changed Power Up Timing diagram VSUP ramp voltage level for INH turn on and timing. Go
- Deleted CLKOUT from the GPIO1 circuit in Figure 8-2
Go
- Deleted CLKOUT: Off from Sleep Mode section in Figure 8-14
Go
- Deleted CLKOUT: Off From Sleep Mode section in Figure 8-15
Go
- Deleted bits 15 and 14 from GPO1_CONFIG from in Table 8-16
Go
- Changed CLKOUT_GPIO1_CONFIG To: GPIO1_CONFIG for GPO1_CONFIG in Table 8-16
Go
- Changed the name of offset 1048 From: TDCE To: TDCR Go