4.2 TMS570LC43x and RM57x HDK

1. Under the ‘Driver Enable’ tab, enable EMAC Driver and SCI1 Driver.
2. Under ‘VIM RAM’ add the names of the ISRs for EMAC Transmit and Receive Interrupts (Channels 77 and 79, respectively).
3. Enable these interrupts under the ‘VIM Channel 64-95’ tab.
4. Under the ‘PLL’ tab, change the multiplier for both PLLs to a value of 150, such that the output frequency in both cases is 300.00 MHz.
5. Under the ‘GCM’ tab, change the value of the VCLK1, VCLK2 and VCLK3 Dividers to 1 and VCLKA4 Divider to 2, such that the output of VCLKA4_DIV is 37.50 MHz.
6. Under the ‘PINMUX’ tab, enable RMII/MII, under Pin Muxing. Under Input Muxing, enable MDIO(G3), MII_COL(F3), MII_CRS(B4), MII_RX_DV(B11), MII_RX_ER(N19), MII_RXCLK(K19), MII_RXD[0], MII_RXD[1], MII_RXD[2], MII_RXD[3], MII_TX_CLK.
7. Under the ‘EMAC’ tab, change the EMAC address to the correct address (the default one in the example is mentioned above). The physical address is 1 by default.
8. Generate the system initialization and HAL Code.