ZHCSCR7A June 2014 – November 2020 TPS2559
PRODUCTION DATA
- 1 特性
- 2 應用
- 3 說明
- 4 Revision History
- 5 Device Comparison Table
- 6 Pin Configuration and Functions
- 7 Specifications
- 8 Detailed Description
-
9 Application and Implementation
- 9.1 Application Information
- 9.2
Typical Application
- 9.2.1 Design Requirements
- 9.2.2
Detailed Design Procedure
- 9.2.2.1 Step-by-Step Design Procedure
- 9.2.2.2 Input and Output Capacitance
- 9.2.2.3 Programming the Current-Limit Threshold
- 9.2.2.4 Design Above a Minimum Current Limit
- 9.2.2.5 Design Below a Maximum Current Limit
- 9.2.2.6 Accounting for Resistor Tolerance
- 9.2.2.7 Power Dissipation and Junction Temperature
- 9.2.2.8 Auto-Retry
- 9.2.2.9 Two-Level Current-Limit
- 9.2.3 Application Curves
- 10Power Supply Recommendations
- 11Layout
- 12Device and Documentation Support
- 13Mechanical, Packaging, and Orderable Information
封裝選項
機械數據 (封裝 | 引腳)
- DRC|10
散熱焊盤機械數據 (封裝 | 引腳)
- DRC|10
訂購信息
6 Pin Configuration and Functions
Figure 6-1 DRC
Package,10-Pin
VSON,Top
ViewTable 6-1 Pin Functions
| PIN | TYPE | DESCRIPTION | |
|---|---|---|---|
| NAME | NO. | ||
| GND | 1 | Ground connection, connect externally to PowerPAD. | |
| IN | 2, 3, 4 | I | Input voltage, connect a 0.1 μF or greater ceramic capacitor from IN to GND as close to the device as possible. |
| EN | 5 | I | Enable input, logic high turns on power switch. |
| ILIM | 6 | O | External resistor used to set current-limit threshold; recommended. 24.9 kΩ ≤ R(ILIM) ≤ 100 kΩ. |
| OUT | 7, 8, 9 | O | Power-switch output. |
| FAULT | 10 | O | Active-low open-drain output, asserted during over-current or overtemperature conditions. |
| PowerPAD? | PAD | — | Internally connected to GND; used to heat-sink the part to the circuit board traces. Connect PowerPAD to GND pin externally. |