ZHCSEF7G December   2014  – February 2019 TPS659037

PRODUCTION DATA.  

1. 1 器件概述
   1. 1.1 特性
   2. 1.2 應用
   3. 1.3 說明
   4. 1.4 簡化方框圖
2. 2 修訂歷史記錄
3. 3 Pin Configuration and Functions
   1.     Pin Functions
4. 4 Specifications
   1. 4.1  Absolute Maximum Ratings
   2. 4.2  ESD Ratings
   3. 4.3  Recommended Operating Conditions
   4. 4.4  Thermal Information
   5. 4.5  Electrical Characteristics: Latch Up Rating
   6. 4.6  Electrical Characteristics: LDO Regulator
   7. 4.7  Electrical Characteristics: Dual-Phase (SMPS12 and SMPS45) and Triple-Phase (SMPS123 and SMPS457) Regulators
   8. 4.8  Electrical Characteristics: Stand-Alone Regulators (SMPS3, SMPS6, SMPS7, SMPS8, and SMPS9)
   9. 4.9  Electrical Characteristics: Reference Generator (Bandgap)
   10. 4.10 Electrical Characteristics: 16-MHz Crystal Oscillator, 32-kHz RC Oscillator, and Output Buffers
   11. 4.11 Electrical Characteristics: DC-DC Clock Sync
   12. 4.12 Electrical Characteristics: 12-Bit Sigma-Delta ADC
   13. 4.13 Electrical Characteristics: Thermal Monitoring and Shutdown
   14. 4.14 Electrical Characteristics: System Control Threshold
   15. 4.15 Electrical Characteristics: Current Consumption
   16. 4.16 Electrical Characteristics: Digital Input Signal Parameters
   17. 4.17 Electrical Characteristics: Digital Output Signal Parameters
   18. 4.18 Electrical Characteristics: I/O Pullup and Pulldown
   19. 4.19 I2C Interface Timing Requirements
   20. 4.20 SPI Timing Requirements
   21. 4.21 Typical Characteristics
5. 5 Detailed Description
   1. 5.1 Overview
   2. 5.2 Functional Block Diagram
   3. 5.3 Feature Description
      1. 5.3.1  Power Management
      2. 5.3.2  Power Resources (Step-Down and Step-Up SMPS Regulators, LDOs)
         1. 5.3.2.1 Step-Down Regulators
            1. 5.3.2.1.1 Sync Clock Functionality
            2. 5.3.2.1.2 Output Voltage and Mode Selection
            3. 5.3.2.1.3 Current Monitoring and Short Circuit Detection
            4. 5.3.2.1.4 POWERGOOD
            5. 5.3.2.1.5 DVS-Capable Regulators
            6. 5.3.2.1.6 Non DVS-Capable Regulators
            7. 5.3.2.1.7 Step-Down Converters SMPS12 and SMPS123
               1.         a. Dual-Phase SMPS and Stand-Alone SMPS
               2.         b. Triple Phase SMPS
            8. 5.3.2.1.8 Step-Down Converter SMPS45 and SMPS457
            9. 5.3.2.1.9 Step-Down Converters SMPS3, SMPS6, SMPS7, SMPS8, and SMPS9
         2. 5.3.2.2 LDOs – Low Dropout Regulators
            1. 5.3.2.2.1 LDOVANA
            2. 5.3.2.2.2 LDOVRTC
            3. 5.3.2.2.3 LDO Bypass (LDO9)
            4. 5.3.2.2.4 LDOUSB
            5. 5.3.2.2.5 Other LDOs
      3. 5.3.3  Long-Press Key Detection
      4. 5.3.4  RTC
         1. 5.3.4.1 General Description
         2. 5.3.4.2 Time Calendar Registers
            1. 5.3.4.2.1 TC Registers Read Access
            2. 5.3.4.2.2 TC Registers Write Access
         3. 5.3.4.3 RTC Alarm
         4. 5.3.4.4 RTC Interrupts
         5. 5.3.4.5 RTC 32-kHz Oscillator Drift Compensation
      5. 5.3.5  GPADC – 12-Bit Sigma-Delta ADC
         1. 5.3.5.1 Asynchronous Conversion Request (SW)
         2. 5.3.5.2 Periodic Conversion Request (AUTO)
         3. 5.3.5.3 Calibration
      6. 5.3.6  General-Purpose I/Os (GPIO Pins)
         1. 5.3.6.1 REGEN Output
      7. 5.3.7  Thermal Monitoring
         1. 5.3.7.1 Hot-Die Function (HD)
         2. 5.3.7.2 Thermal Shutdown (TS)
         3. 5.3.7.3 Temperature Monitoring With External NTC Resistor or Diode
      8. 5.3.8  Interrupts
      9. 5.3.9  Control Interfaces
         1. 5.3.9.1 I2C Interfaces
            1. 5.3.9.1.1 I2C Implementation
            2. 5.3.9.1.2 F/S Mode Protocol
            3. 5.3.9.1.3 HS Mode Protocol
         2. 5.3.9.2 Serial-Peripheral Interface (SPI)
            1. 5.3.9.2.1 SPI Modes
            2. 5.3.9.2.2 SPI Protocol
      10. 5.3.10 Device Identification
   4. 5.4 Device Functional Modes
      1. 5.4.1  Embedded Power Controller
      2. 5.4.2  State Transition Requests
         1. 5.4.2.1 ON Requests
         2. 5.4.2.2 OFF Requests
         3. 5.4.2.3 SLEEP and WAKE Requests
      3. 5.4.3  Power Sequences
      4. 5.4.4  Startup Timing and RESET_OUT Generation
      5. 5.4.5  Power On Acknowledge
         1. 5.4.5.1 POWERHOLD Mode
         2. 5.4.5.2 AUTODEVON Mode
      6. 5.4.6  BOOT Configuration
         1. 5.4.6.1 Boot Pin Selection
      7. 5.4.7  Reset Levels
      8. 5.4.8  Warm Reset
      9. 5.4.9  RESET_IN
      10. 5.4.10 Watchdog Timer (WDT)
      11. 5.4.11 System Voltage Monitoring
          1. 5.4.11.1 Generating a POR
6. 6 Application and Implementation
   1. 6.1 Application Information
   2. 6.2 Typical Application
      1. 6.2.1 Design Requirements
      2. 6.2.2 Detailed Design Procedure
         1. 6.2.2.1  Recommended External Components
         2. 6.2.2.2  SMPS Input Capacitors
         3. 6.2.2.3  SMPS Output Capacitors
         4. 6.2.2.4  SMPS Inductors
         5. 6.2.2.5  LDO Input Capacitors
         6. 6.2.2.6  LDO Output Capacitors
         7. 6.2.2.7  VCC1
            1. 6.2.2.7.1 Meeting the Power Down Sequence
            2. 6.2.2.7.2 Maintaining Sufficient Input Voltage
         8. 6.2.2.8  VIO_IN
         9. 6.2.2.9  16-MHz Crystal
         10. 6.2.2.10 GPADC
      3. 6.2.3 Application Curves
7. 7 Power Supply Recommendations
8. 8 Layout
   1. 8.1 Layout Guidelines
   2. 8.2 Layout Example
9. 9 器件和文檔支持
   1. 9.1 器件支持
      1. 9.1.1 第三方產(chǎn)品免責聲明
   2. 9.2 文檔支持
      1. 9.2.1 相關文檔
   3. 9.3 接收文檔更新通知
   4. 9.4 社區(qū)資源
   5. 9.5 商標
   6. 9.6 靜電放電警告
   7. 9.7 Glossary
10. 10機械、封裝和可訂購信息