ZHCSR16 September 2022 TPS544C26
ADVANCE INFORMATION
| CMD Address | 03h |
| Write Transaction: | Send Byte |
| Read Transaction: | N/A |
| Format: | Data-less |
| NVM Back-up: | No |
| Updates: | On-the-fly |
CLEAR_FAULTS is a command used to clear any fault bits that have been set. CLEAR_FAULTS is a write-only command with no data. Writing a "1" into bit[0] of this command clears all bits in all status registers. The bit clears itself after the write.
The CLEAR_FAULTS command does not cause a unit that has latched off for a fault condition to restart. If the fault is still present when the bit is cleared, the fault bit is immediately set again.
Return to Supported I2C and Default Values.
| 7 | 6 | 5 | 4 | 3 | 2 | 1 | 0 |
| W | W | W | W | W | W | W | W |
| Reserved | CLEAR_FAULTS | ||||||
| LEGEND: R/W = Read/Write; R = Read only |