RDRNn: RDRNn should be a 47-Ω, 5%, 0.1-W resistor in an 0603 SMT package.
RSENn: RSENn should be a 22.1-Ω, 1%, 0.1-W resistor in an 0603 SMT package.
CPn: 0.1-µF, 100-V, X7R ceramic between VPWR and Pn-
RSnA / RSnB: The port current sense resistors can be either a combination of two 0.51-Ω, 1% resistors in parallel (0.255 Ω) or four 1.00-Ω, 1% resistors in parallel (0.250 Ω). The most common usage employs dual 0.51-Ω, 1%, 0.25-W resistors in an 0805 SMT package. Power dissipation for the resistor pair at maximum ICUT is approximately 117 mW (~58 mW each).
QPn: The port MOSFET can be a small, inexpensive device with average performance characteristics.
BVDSS should be 100 V minimum for high voltage surge environment considerations.
RDS(on) (VGS = 10 V) should be between 50 mΩ and 150 mΩ for power dissipation considerations.
The power dissipation for QPn with RDS(on) = 100 mΩ at maximum ICUT is approximately 46 mW.
Input capacitance (CISS) should be less than 2000 pF.
Gate Charge (QG) at VGATEn = 12.5 V should be less than 50 nC (see NOTE below).
NOTE
For applications requiring faster response times under soft overload conditions (1 to 1.5 x ILIM), QG @ VGATEn = 12.5 V may be required to be << 50 nC.
FPn: The port fuse should be a slow blow type rated for at least 60 VDC and above ~2 x ICUT(max). The cold resistance should be below 200 mΩ to reduce the DC losses. The power dissipation for FPn with a cold resistance of 180 mΩ at maximum ICUT is approximately 83 mW.
DPnA: The port TVS should be rated for the expected port surge environment. DPnA should have a minimum reverse standoff voltage of 58 V and a maximum clamping voltage of 95 V at the expected peak surge current.
DPnB: The negative clamp diode is optional for extreme surge environments. DPnB should be rated for VR = 100 V minimum and be able to survive the expected surge current. Low forward voltage drop at the rated current is beneficial.