ZHCSH61R October 2017 – November 2021 TLV9001 , TLV9002 , TLV9004
PRODUCTION DATA
請參考 PDF 數據表獲取器件具體的封裝圖。
| 參數 | 測試條件 | 最小值 | 典型值 | 最大值 | 單位 | |||
|---|---|---|---|---|---|---|---|---|
| 失調電壓 | ||||||||
| VOS | 輸入失調電壓 | VS = 5V | ±0.4 | ±1.6 | mV | |||
| VS = 5V，TA = –40°C 至 125°C | ±2 | |||||||
| dVOS/dT | VOS 溫漂 | TA = –40°C 至 125°C | ±0.6 | μV/°C | ||||
| PSRR | 電源抑制比 | VS = 1.8 至 5.5V，VCM = (V–) | 80 | 105 | dB | |||
| 輸入電壓范圍 | ||||||||
| VCM | 共模電壓范圍 | 無相位反向，軌到軌輸入 | (V–) – 0.1 | (V+)+0.1 | V | |||
| CMRR | 共模抑制比 | VS = 1.8V，(V–) – 0.1V < VCM < (V+) – 1.4V， TA = –40°C 至 125°C | 86 | dB | ||||
| VS = 5.5V，(V–) – 0.1V < VCM < (V+) – 1.4V， TA = –40°C 至 125°C | 95 | |||||||
| VS = 5.5V，(V–) – 0.1V < VCM < (V+) + 0.1V， TA = –40°C 至 125°C | 63 | 77 | ||||||
| VS = 1.8V，(V–) – 0.1V < VCM < (V+) + 0.1V， TA = –40°C 至 125°C | 68 | |||||||
| 輸入偏置電流 | ||||||||
| IB | 輸入偏置電流 | VS = 5V | ±5 | pA | ||||
| IOS | 輸入失調電流 | ±2 | pA | |||||
| 噪聲 | ||||||||
| En | 輸入電壓噪聲（峰峰值） | ? = 0.1Hz 至 10Hz，VS = 5V | 4.7 | μVPP | ||||
| en | 輸入電壓噪聲密度 | ? = 1kHz，VS = 5V | 30 | nV/√Hz | ||||
| ? = 10kHz，VS = 5V | 27 | |||||||
| in | 輸入電流噪聲密度 | ? = 1kHz，VS = 5V | 23 | fA/√ Hz | ||||
| 輸入電容 | ||||||||
| CID | 差分 | 1.5 | pF | |||||
| CIC | 共模 | 5 | pF | |||||
| 開環增益 | ||||||||
| AOL | 開環電壓增益 | VS = 5.5V，(V–) + 0.05V < VO < (V+) – 0.05V， RL = 10kΩ | 104 | 117 | dB | |||
| VS = 1.8V，(V–) + 0.04V < VO < (V+) – 0.04V， RL = 10kΩ | 100 | |||||||
| VS = 1.8V，(V–) + 0.1V < VO < (V+) – 0.1V， RL = 2kΩ | 115 | |||||||
| VS = 5.5V，(V–) + 0.15V < VO < (V+) – 0.15V， RL = 2kΩ | 130 | |||||||
| 頻率響應 | ||||||||
| GBW | 增益帶寬積 | VS = 5V | 1 | MHz | ||||
| φm | 相位裕度 | VS = 5.5V，G = 1 | 78 | ° | ||||
| SR | 壓擺率 | VS = 5V | 2 | V/μs | ||||
| tS | 趨穩時間 | 精度達到 0.1%，VS = 5V，2V 階躍，G = +1，CL = 100pF | 2.5 | μs | ||||
| 精度達到 0.01%，VS = 5V，2V 階躍，G = +1，CL = 100pF | 3 | |||||||
| tOR | 過載恢復時間 | VS = 5V，VIN × 增益 > VS | 0.85 | μs | ||||
| THD+N | 總諧波失真 + 噪聲 | VS = 5.5V，VCM = 2.5V，VO = 1VRMS，G = +1， ? = 1kHz，80kHz 測量 BW | 0.004% | |||||
| 輸出 | ||||||||
| VO | 相對于電源軌的電壓輸出擺幅 | VS = 5.5V，RL = 10kΩ | 10 | 20 | mV | |||
| VS=5.5V，RL=2kΩ | 35 | 55 | ||||||
| ISC | 短路電流 | VS = 5.5V | ±40 | mA | ||||
| ZO | 開環輸出阻抗 | VS = 5V，? = 1MHz | 1200 | Ω | ||||
| 電源 | ||||||||
| VS | 額定電壓范圍 | 1.8 (±0.9) | 5.5 (±2.75) | V | ||||
| IQ | 每個放大器的靜態電流 | TLV9002、TLV9002S、TLV9004、TLV9004S | IO = 0mA，VS = 5.5V | 60 | 75 | μA | ||
| TLV9001、TLV9001S | IO = 0mA，VS = 5.5V | 60 | 77 | |||||
| IO = 0mA，VS = 5.5V，TA = –40°C 至 125°C | 85 | |||||||
| 關斷(1) | ||||||||
| IQSD | 每個放大器的靜態電流 | VS = 1.8V 至 5.5V，所有放大器為禁用狀態，SHDN = VS– | 0.5 | 1.5 | μA | |||
| ZSHDN | 關斷時的輸出阻抗 | VS = 1.8V 至 5.5V，放大器為禁用狀態 | 10 || 2 | GΩ || pF | ||||
| 高電平電壓關斷閾值（放大器為啟用狀態） | VS = 1.8V 至 5.5V | (V–) + 0.9 | (V–) + 1.1 | V | ||||
| 低電平電壓關斷閾值（放大器為禁用狀態） | VS = 1.8V 至 5.5V | (V–) + 0.2 V | (V–) + 0.7 V | V | ||||
| tON | 放大器啟用時間（完全關斷） | VS = 1.8V 至 5.5V，完全關斷；G = 1， VOUT = 0.9 × VS / 2，RL 連接到 V– | 70 | μs | ||||
| 放大器啟用時間（部分關斷） | VS = 1.8V 至 5.5V，部分關斷；G = 1， VOUT = 0.9 × VS / 2, RL 連接到 V– | 50 | ||||||
| tOFF | 放大器禁用時間 | VS = 1.8V 至 5.5V，G = 1，VOUT = 0.1 × VS /2， RL 連接到 V– | 4 | μs | ||||
| SHDN 引腳輸入偏置電流（每個引腳） | VS = 1.8V 至 5.5V，V+ ≥ SHDN ≥ (V+) – 0.8V | 40 | nA | |||||
| VS = 1.8V 至 5.5V，V– ≤ SHDN ≤ V– + 0.8V | 150 | |||||||