ZHCS904I May   2012  – March 2017 TRF7964A

PRODUCTION DATA.  

1. 1器件概述
   1. 1.1 特性
   2. 1.2 應用范圍
   3. 1.3 說明
   4. 1.4 功能方框圖
2. 2修訂歷史記錄
3. 3Device Characteristics
   1. 3.1 Related Products
4. 4Terminal Configuration and Functions
   1. 4.1 Pin Diagram
   2. 4.2 Signal Descriptions
5. 5Specifications
   1. 5.1 Absolute Maximum Ratings
   2. 5.2 ESD Ratings
   3. 5.3 Recommended Operating Conditions
   4. 5.4 Electrical Characteristics
   5. 5.5 Thermal Resistance Characteristics
   6. 5.6 Switching Characteristics
6. 6Detailed Description
   1. 6.1  Overview
      1. 6.1.1 RFID - Reader and Writer
   2. 6.2  System Block Diagram
   3. 6.3  Power Supplies
      1. 6.3.1 Supply Arrangements
      2. 6.3.2 Supply Regulator Settings
      3. 6.3.3 Power Modes
   4. 6.4  Receiver - Analog Section
      1. 6.4.1 Main and Auxiliary Receivers
      2. 6.4.2 Receiver Gain and Filter Stages
   5. 6.5  Receiver - Digital Section
      1. 6.5.1 Received Signal Strength Indicator (RSSI)
         1. 6.5.1.1 Internal RSSI - Main and Auxiliary Receivers
         2. 6.5.1.2 External RSSI
   6. 6.6  Oscillator Section
   7. 6.7  Transmitter - Analog Section
   8. 6.8  Transmitter - Digital Section
   9. 6.9  Transmitter - External Power Amplifier and Subcarrier Detector
   10. 6.10 TRF7964A IC Communication Interface
       1. 6.10.1 General Introduction
          1. 6.10.1.1 Continuous Address Mode
          2. 6.10.1.2 Noncontinuous Address Mode (Single Address Mode)
          3. 6.10.1.3 Direct Command Mode
          4. 6.10.1.4 FIFO Operation
       2. 6.10.2 Parallel Interface Mode
       3. 6.10.3 Reception of Air Interface Data
       4. 6.10.4 Data Transmission From MCU to TRF7964A
       5. 6.10.5 Serial Interface Communication (SPI)
          1. 6.10.5.1 Serial Interface Mode With Slave Select (SS)
       6. 6.10.6 Direct Mode
   11. 6.11 TRF7964A Initialization
   12. 6.12 Special Direct Mode for Improved MIFARE Compatibility
   13. 6.13 Direct Commands from MCU to Reader
       1. 6.13.1 Command Codes
          1. 6.13.1.1  Idle (0x00)
          2. 6.13.1.2  Software Initialization (0x03)
          3. 6.13.1.3  Reset FIFO (0x0F)
          4. 6.13.1.4  Transmission With CRC (0x11)
          5. 6.13.1.5  Transmission Without CRC (0x10)
          6. 6.13.1.6  Delayed Transmission With CRC (0x13)
          7. 6.13.1.7  Delayed Transmission Without CRC (0x12)
          8. 6.13.1.8  Transmit Next Time Slot (0x14)
          9. 6.13.1.9  Block Receiver (0x16)
          10. 6.13.1.10 Enable Receiver (0x17)
          11. 6.13.1.11 Test Internal RF (RSSI at RX Input With TX ON) (0x18)
          12. 6.13.1.12 Test External RF (RSSI at RX Input with TX OFF) (0x19)
   14. 6.14 Register Description
       1. 6.14.1 Register Preset
       2. 6.14.2 Register Overview
       3. 6.14.3 Detailed Register Description
          1. 6.14.3.1 Main Configuration Registers
             1. 6.14.3.1.1 Chip Status Control Register (0x00)
             2. 6.14.3.1.2 ISO Control Register (0x01)
          2. 6.14.3.2 Control Registers - Sublevel Configuration Registers
             1. 6.14.3.2.1  ISO/IEC 14443 TX Options Register (0x02)
             2. 6.14.3.2.2  ISO/IEC 14443 High-Bit-Rate and Parity Options Register (0x03)
             3. 6.14.3.2.3  TX Timer High Byte Control Register (0x04)
             4. 6.14.3.2.4  TX Timer Low Byte Control Register (0x05)
             5. 6.14.3.2.5  TX Pulse Length Control Register (0x06)
             6. 6.14.3.2.6  RX No Response Wait Time Register (0x07)
             7. 6.14.3.2.7  RX Wait Time Register (0x08)
             8. 6.14.3.2.8  Modulator and SYS_CLK Control Register (0x09)
             9. 6.14.3.2.9  RX Special Setting Register (0x0A)
             10. 6.14.3.2.10 Regulator and I/O Control Register (0x0B)
          3. 6.14.3.3 Status Registers
             1. 6.14.3.3.1 IRQ Status Register (0x0C)
             2. 6.14.3.3.2 Interrupt Mask Register (0x0D) and Collision Position Register (0x0E)
             3. 6.14.3.3.3 RSSI Levels and Oscillator Status Register (0x0F)
             4. 6.14.3.3.4 Special Functions Register (0x10)
             5. 6.14.3.3.5 Special Functions Register (0x11)
             6. 6.14.3.3.6 Adjustable FIFO IRQ Levels Register (0x14)
          4. 6.14.3.4 Test Registers
             1. 6.14.3.4.1 Test Register (0x1A)
             2. 6.14.3.4.2 Test Register (0x1B)
          5. 6.14.3.5 FIFO Control Registers
             1. 6.14.3.5.1 FIFO Status Register (0x1C)
             2. 6.14.3.5.2 TX Length Byte1 Register (0x1D), TX Length Byte2 Register (0x1E)
7. 7Applications, Implementation, and Layout
   1. 7.1 TRF7964A Reader System Using SPI With SS Mode
      1. 7.1.1 General Application Considerations
      2. 7.1.2 Schematic
   2. 7.2 Layout Considerations
   3. 7.3 Impedance Matching TX_Out (Pin 5) to 50 ?
   4. 7.4 Reader Antenna Design Guidelines
8. 8器件和文檔支持
   1. 8.1 入門和下一步
   2. 8.2 器件命名規則
   3. 8.3 工具與軟件
   4. 8.4 文檔支持
   5. 8.5 社區資源
   6. 8.6 商標
   7. 8.7 靜電放電警告
   8. 8.8 Glossary
9. 9機械、封裝和可訂購信息