一色桃子欲求不满人妻,香蕉久久人人97超碰caoproen,久久久久国内精品影院

ZHCSDR2A April 2015 – October 2024 FDC1004-Q1

PRODUCTION DATA

封裝選項

機械數(shù)據(jù) (封裝 | 引腳)

DGS|10
- MPDS035C

散熱焊盤機械數(shù)據(jù) (封裝 | 引腳)

訂購信息

5.5 Electrical Characteristics

Over recommended operating temperature range, V_DD = 3.3V, for T_A = 25°C (unless otherwise noted). ⁽¹⁾

PARAMETER		TEST CONDITION	TYP⁽³⁾	MAX⁽²⁾	UNIT
POWER SUPPLY
I_DD	Supply current	Conversion mode; Digital input to VDD or GND	750	950	μA
I_DD	Supply current	Standby; Digital input to VDD or GND	29	70	μA
CAPACITIVE INPUT
ICR	Input conversion range		±15		pF
C_OMAX	Max input offset capacitance	per channel, Series resistance at CINn n=1.4 = 0 Ω	100		pF
RES	Effective resolution ⁽⁵⁾	Sample rate = 100S/s ⁽⁴⁾	16		bit
EON	Output noise	Sample rate = 100S/s ⁽⁴⁾	33.2		aF/√Hz
ERR	Absolute error	after offset calibration	±6		fF
TcC_OFF	Offset deviation over temperature	-40°C < T < 125°C	46		fF
G_ERR	Gain error		0.2%
tcG	Gain drift vs temperature	-40°C < T < 125°C	-37.5		ppm/°C
PSRR	DC power supply rejection	3V < V_DD < 3.6V, single-ended mode (channel vs GND)	13.6		fF/V
CAPDAC
FR_CAPDAC	Full-scale range		96.9		pF
TcCOFF_CAPDAC	Offset drift vs temperature	-40°C < T < 125°C	30		fF
EXCITATION
?	Frequency		25		kHz
V_AC	AC voltage across capacitance		2.4		Vpp
V_DC	Average DC voltage across capacitance		1.2		V
SHIELD
DRV	Driver capability	? = 25kHz, SHLDn to GND, n = 1,2		400	pF

(1) Electrical Characteristics Table values apply only for factory testing conditions at the temperature indicated. Factory testing conditions result in very limited self-heating of the device such that TJ=TA. No guarantee of parametric performance is indicated in the electrical tables under conditions of internal self-heating where TJ>TA. Absolute Maximum Ratings indicate junction temperature limits beyond which the device can be permanently degraded, either mechanically or electrically.

(2) Limits are ensured by testing, design, or statistical analysis at 25Degree C. Limits over the operating temperature range are ensured through correlations using statistical quality control (SQC) method.

(3) Typical values represent the most likely parametric norm as determined at the time of characterization. Actual typical values can vary over time and also depend on the application and configuration. The typical values are not tested and are not guaranteed on shipped production material.

(4) No external capacitance connected.

(5) Effective resolution is the ratio of converter full scale range to RMS measurement noise.