ZHCSG57B March 2017 – December 2018 DRV8702D-Q1 , DRV8703D-Q1
PRODUCTION DATA.
請(qǐng)參考 PDF 數(shù)據(jù)表獲取器件具體的封裝圖。
An MCU watchdog function can be enabled to ensure that the external controller that is instructing the DRV8703D-Q1 device is active and in a known state. The SPI watchdog must be enabled by writing a 1 to the WD_EN bit through the SPI (disabled by default, bit is 0). When the watchdog is enabled, an internal timer starts to count down to an interval set by the WD_DLY bits. The register address 0x00 must be read by the MCU within the interval set by the WD_DLY bit to reset the watchdog. If the timer is allowed to expire, the nWDFLT pin is enabled. When the nWDFLT pin is enabled the following occurs:
The WDFLT bit remains asserted, and operation is halted until the CLR_FLT bit has been written to 1.
Table 8 lists the fault responses of the device under the fault conditions.
| FAULT | CONDITION | HALF-BRIDGE | CHARGE PUMP | AVDD | DVDD | RECOVERY |
|---|---|---|---|---|---|---|
| VM undervoltage
(UVLO) |
VVM ≤ V(UVLOx)
(5.45 V, max) |
Disabled | Disabled | Disabled | Operating | VVM ≥ V(UVLOx)
(5.65 V, max) |
| VCP undervoltage
(CPUV) |
VVCP ≤ V(CP_UV)
(VVM + 1.5, typ) |
Disabled | Operating | Operating | Operating | VVCP ≥ V(CP_UV)
(VVM + 1.5, typ) |
| External FET overload
(OCP) |
VDS ≥ VDS(OCP)
VSP – VSN > 1 V |
Disabled | Operating | Operating | Operating | t(RETRY) |
| Gate driver fault
(GDF) |
Gate voltage unchanged after t(DRIVE) | Disabled | Operating | Operating | Operating | t(RETRY) |
| Watchdog fault
(WDFLT) |
Watchdog timer expires | Disabled | Operating | Operating | Operating | CLR_FLT bit |
| Thermal shutdown
(TSD) |
TJ ≥ TSD (150°C, min) | Disabled | Disabled | Disabled | Operating | TJ ≤ TSD – Thys
(Thys is typically 20°C) |