久久日本精品无码无码人妻精品一区二区三区 ,亚洲精品成a人在线观看☆,国产成人综合亚洲亚洲欧美

ZHCS896I May 2009 – September 2018 CC430F5133 , CC430F5135 , CC430F5137 , CC430F6125 , CC430F6126 , CC430F6127 , CC430F6135 , CC430F6137

PRODUCTION DATA.

封裝選項

機械數據 (封裝 | 引腳)

RGC|64
- MPQF125F

散熱焊盤機械數據 (封裝 | 引腳)

RGC|64
- QFND102O

訂購信息

5.45.18 RF Transmit

T_A = 25°C, V_CC = 3 V (unless otherwise noted)⁽¹⁾
P_TX = +10 dBm (unless otherwise noted)

PARAMETER	FREQUENCY (MHz)	TEST CONDITIONS		TYP	UNIT
Differential load impedance⁽¹⁾	315			122 + j31	Ω
	433			116 + j41
	868, 915			86.5 + j43
Output power, highest setting⁽²⁾	315	Delivered to a 50-Ω single-ended load from CC430 reference design RF matching network		+12	dBm
	433			+13
	868			+11
	915			+11
Output power, lowest setting⁽²⁾		Delivered to a 50-Ω single-ended load from CC430 reference design RF matching network		–30	dBm
Harmonics, radiated⁽³⁾⁽⁴⁾⁽⁵⁾	433	Second harmonic		–56	dBm
	433	Third harmonic		–57
	868	Second harmonic		–50
	868	Third harmonic		–52
	915	Second harmonic		–50
	915	Third harmonic		–54
Harmonics, conducted	315	Frequencies below 960 MHz	+10 dBm CW	< –38	dBm
	315	Frequencies above 960 MHz	+10 dBm CW	< –48
	433	Frequencies below 1 GHz	+10 dBm CW	–45
	433	Frequencies above 1 GHz	+10 dBm CW	< –48
	868	Second harmonic	+10 dBm CW	–59
	868	Other harmonics	+10 dBm CW	< –71
	915	Second harmonic	+11 dBm CW⁽⁶⁾	–53
	915	Other harmonics	+11 dBm CW⁽⁶⁾	< –47
Spurious emissions, conducted, harmonics not included⁽⁷⁾	315	Frequencies below 960 MHz	+10 dBm CW	< –58	dBm
	315	Frequencies above 960 MHz	+10 dBm CW	< –53
	433	Frequencies below 1 GHz	+10 dBm CW	< –54
		Frequencies above 1 GHz		< –54
		Frequencies from 47 to 74, 87.5 to 118, 174 to 230, 470 to 862 MHz		< –63
	868	Frequencies below 1 GHz	+10 dBm CW	< –46
		Frequencies above 1 GHz		< –59
		Frequencies from 47 to 74, 87.5 to 118, 174 to 230, 470 to 862 MHz		< –56
	915	Frequencies below 960 MHz	+11 dBm CW	< –49
	915	Frequencies above 960 MHz	+11 dBm CW	< –63
TX latency⁽⁸⁾		Serial operation		8	bits

(1) Differential impedance as seen from the RF port (RF_P and RF_N) towards the antenna. Follow the CC430 reference designs available from the TI website.

(2) Output power is programmable, and the full range is available in all frequency bands. Output power may be restricted by regulatory limits. Also see AN050 Using the CC1101 in the European 868MHz SRD Band and DN013 Programming Output Power on CC1101, which gives the output power and harmonics when using multilayer inductors. The output power is then typically +10 dBm when operating at 868 or 915 MHz.

(3) The antennas used during the radiated measurements (SMAFF-433 from R.W.Badland and Nearson S331 868/915) play a part in attenuating the harmonics.

(4) Measured on EM430F6137RF900 with CW, maximum output power

(5) All harmonics are below –41.2 dBm when operating in the 902 to 928 MHz band.

(6) Requirement is –20 dBc under FCC 15.247.

(7) All radiated spurious emissions are within the limits of ETSI. Also see DN017 CC11xx 868/915 MHz RF Matching.

(8) Time from sampling the data on the transmitter data input pin until it is observed on the RF output ports