ZHCS896I May   2009  – September 2018 CC430F5133 , CC430F5135 , CC430F5137 , CC430F6125 , CC430F6126 , CC430F6127 , CC430F6135 , CC430F6137

PRODUCTION DATA.  

1. 1器件概述
   1. 1.1 特性
   2. 1.2 應用
   3. 1.3 說明
   4. 1.4 功能方框圖
2. 2修訂歷史記錄
3. 3Device Comparison
   1. 3.1 Related Products
4. 4Terminal Configuration and Functions
   1. 4.1 Pin Diagrams
   2. 4.2 Signal Descriptions
      1. Table 4-1 CC430F613x and CC430F612x Terminal Functions
      2. Table 4-2 CC430F513x Terminal Functions
5. 5Specifications
   1. 5.1  Absolute Maximum Ratings
   2. 5.2  ESD Ratings
   3. 5.3  Recommended Operating Conditions
   4. 5.4  Active Mode Supply Current Into VCC Excluding External Current
   5. 5.5  Typical Characteristics – Active Mode Supply Currents
   6. 5.6  Low-Power Mode Supply Currents (Into VCC) Excluding External Current
   7. 5.7  Typical Characteristics – Low-Power Mode Supply Currents
   8. 5.8  Low-Power Mode With LCD Supply Currents (Into VCC) Excluding External Current
   9. 5.9  Thermal Resistance Characteristics, CC430F51xx
   10. 5.10 Thermal Resistance Characteristics, CC430F61xx
   11. 5.11 Digital Inputs
   12. 5.12 Digital Outputs
   13. 5.13 Typical Characteristics – Outputs, Reduced Drive Strength (PxDS.y = 0)
   14. 5.14 Typical Characteristics – Outputs, Full Drive Strength (PxDS.y = 1)
   15. 5.15 Crystal Oscillator, XT1, Low-Frequency Mode
   16. 5.16 Internal Very-Low-Power Low-Frequency Oscillator (VLO)
   17. 5.17 Internal Reference, Low-Frequency Oscillator (REFO)
   18. 5.18 DCO Frequency
   19. 5.19 PMM, Brownout Reset (BOR)
   20. 5.20 PMM, Core Voltage
   21. 5.21 PMM, SVS High Side
   22. 5.22 PMM, SVM High Side
   23. 5.23 PMM, SVS Low Side
   24. 5.24 PMM, SVM Low Side
   25. 5.25 Wake-up Times From Low-Power Modes and Reset
   26. 5.26 Timer_A
   27. 5.27 USCI (UART Mode) Clock Frequency
   28. 5.28 USCI (UART Mode)
   29. 5.29 USCI (SPI Master Mode) Clock Frequency
   30. 5.30 USCI (SPI Master Mode)
   31. 5.31 USCI (SPI Slave Mode)
   32. 5.32 USCI (I2C Mode)
   33. 5.33 LCD_B Operating Conditions
   34. 5.34 LCD_B Electrical Characteristics
   35. 5.35 12-Bit ADC, Power Supply and Input Range Conditions
   36. 5.36 12-Bit ADC, Timing Parameters
   37. 5.37 12-Bit ADC, Linearity Parameters Using an External Reference Voltage or AVCC as Reference Voltage
   38. 5.38 12-Bit ADC, Linearity Parameters Using the Internal Reference Voltage
   39. 5.39 12-Bit ADC, Temperature Sensor and Built-In VMID
   40. 5.40 REF, External Reference
   41. 5.41 REF, Built-In Reference
   42. 5.42 Comparator_B
   43. 5.43 Flash Memory
   44. 5.44 JTAG and Spy-Bi-Wire Interface
   45. 5.45 RF1A CC1101-Based Radio Parameters
       1. 5.45.1  Recommended Operating Conditions
       2. 5.45.2  RF Crystal Oscillator, XT2
       3. 5.45.3  Current Consumption, Reduced-Power Modes
       4. 5.45.4  Current Consumption, Receive Mode
       5. 5.45.5  Current Consumption, Transmit Mode
       6. 5.45.6  Typical TX Current Consumption, 315 MHz
       7. 5.45.7  Typical TX Current Consumption, 433 MHz
       8. 5.45.8  Typical TX Current Consumption, 868 MHz
       9. 5.45.9  Typical TX Current Consumption, 915 MHz
       10. 5.45.10 RF Receive, Overall
       11. 5.45.11 RF Receive, 315 MHz
       12. 5.45.12 RF Receive, 433 MHz
       13. 5.45.13 RF Receive, 868 or 915 MHz
       14. 5.45.14 Typical Sensitivity, 315 MHz, Sensitivity Optimized Setting
       15. 5.45.15 Typical Sensitivity, 433 MHz, Sensitivity Optimized Setting
       16. 5.45.16 Typical Sensitivity, 868 MHz, Sensitivity Optimized Setting
       17. 5.45.17 Typical Sensitivity, 915 MHz, Sensitivity Optimized Setting
       18. 5.45.18 RF Transmit
       19. 5.45.19 Optimum PATABLE Settings for Various Output Power Levels and Frequency Bands
       20. 5.45.20 Typical Output Power, 315 MHz
       21. 5.45.21 Typical Output Power, 433 MHz
       22. 5.45.22 Typical Output Power, 868 MHz
       23. 5.45.23 Typical Output Power, 915 MHz
       24. 5.45.24 Frequency Synthesizer Characteristics
       25. 5.45.25 Typical RSSI_offset Values
6. 6Detailed Description
   1. 6.1  Sub-1 GHz Radio
   2. 6.2  CPU
   3. 6.3  Operating Modes
   4. 6.4  Interrupt Vector Addresses
   5. 6.5  Memory Organization
   6. 6.6  Bootloader (BSL)
   7. 6.7  JTAG Operation
      1. 6.7.1 JTAG Standard Interface
      2. 6.7.2 Spy-Bi-Wire Interface
   8. 6.8  Flash Memory
   9. 6.9  RAM
   10. 6.10 Peripherals
       1. 6.10.1  Oscillator and System Clock
       2. 6.10.2  Power-Management Module (PMM)
       3. 6.10.3  Digital I/O
       4. 6.10.4  Port Mapping Controller
       5. 6.10.5  System Module (SYS)
       6. 6.10.6  DMA Controller
       7. 6.10.7  Watchdog Timer (WDT_A)
       8. 6.10.8  CRC16
       9. 6.10.9  Hardware Multiplier
       10. 6.10.10 AES128 Accelerator
       11. 6.10.11 Universal Serial Communication Interface (USCI)
       12. 6.10.12 TA0
       13. 6.10.13 TA1
       14. 6.10.14 Real-Time Clock (RTC_A)
       15. 6.10.15 Voltage Reference (REF)
       16. 6.10.16 LCD_B (Only CC430F613x and CC430F612x)
       17. 6.10.17 Comparator_B
       18. 6.10.18 ADC12_A (Only CC430F613x and CC430F513x)
       19. 6.10.19 Embedded Emulation Module (EEM) (S Version)
       20. 6.10.20 Peripheral File Map
   11. 6.11 Input/Output Diagrams
       1. 6.11.1  Port P1 (P1.0 to P1.4) Input/Output With Schmitt Trigger
       2. 6.11.2  Port P1 (P1.5 to P1.7) Input/Output With Schmitt Trigger
       3. 6.11.3  Port P2 (P2.0 to P2.7) Input/Output With Schmitt Trigger
       4. 6.11.4  Port P3 (P3.0 to P3.7) Input/Output With Schmitt Trigger
       5. 6.11.5  Port P4 (P4.0 to P4.7) Input/Output With Schmitt Trigger (CC430F613x and CC430F612x Only)
       6. 6.11.6  Port P5 (P5.0 and P5.1) Input/Output With Schmitt Trigger
       7. 6.11.7  Port P5 (P5.2 to P5.4) Input/Output With Schmitt Trigger (CC430F613x and CC430F612x Only)
       8. 6.11.8  Port P5 (P5.5 to P5.7) Input/Output With Schmitt Trigger (CC430F613x and CC430F612x Only)
       9. 6.11.9  Port J (PJ.0) JTAG Pin TDO, Input/Output With Schmitt Trigger or Output
       10. 6.11.10 Port J (PJ.1 to PJ.3) JTAG Pins TMS, TCK, TDI/TCLK, Input/Output With Schmitt Trigger or Output
   12. 6.12 Device Descriptor
7. 7Applications, Implementation, and Layout
   1. 7.1 Application Circuits
8. 8器件和文檔支持
   1. 8.1  入門和后續步驟
   2. 8.2  Device Nomenclature
   3. 8.3  工具和軟件
   4. 8.4  文檔支持
   5. 8.5  相關鏈接
   6. 8.6  社區資源
   7. 8.7  商標
   8. 8.8  靜電放電警告
   9. 8.9  Export Control Notice
   10. 8.10 Glossary
9. 9機械，封裝和可訂購信息