3.3 Initial Setup

The following steps describe the initial setup of the LCDK:

1. Set DIP switch SW1 as shown in Figure 3:
   1. Positions 2, 3, and 4 ON
   2. Positions 1, 5, 6, 7, and 8 OFF
Figure 3. SW1 Settings
2. Connect the supplied mini USB cable to J3 on the LCDK, as shown in Figure 4. Connect the other end of the cable to a USB port on your host computer.
Figure 4. UART-to-USB Port
3. Open a serial port terminal (Tera Term) on the host computer and select the connection to the USB serial port.
Figure 5. Tera Term Port Selection
4. Configure the serial port as shown in Figure 5.
   1. Select the COM port that corresponds to the USB device.
   2. Baud rate: 115200
   3. Data: 8 bit
   4. Parity: none
   5. Stop: 1 bit

   NOTE

   To do this in Tera Term, go to Setup → Serial port.

Figure 6. Tera Term Baud Rate Selection
5. Power the board up.