亚洲成Av人片在线观看不卡,孕妇被C好深啊太粗视频,亚洲国产成人精品日

SLUUC54C February 2020 – March 2024 BQ27Z558 , BQ27Z561 , BQ27Z561-R2

9.8 Valid Charge Termination

The charge termination condition must be met to enable valid charge termination. The device has the following actions at charge termination, based on the bits settings:

If IT Gauging Configuration[CSYNC] = 1, RemainingCapacity() = FullChargeCapacity().
If I2C Gauging Configuration[RSOCL] = 1, RelativeStateOfCharge() and RemainingCapacity() are held at 99% until charge termination occurs. Only on entering charge termination is 100% displayed.
If I2C Gauging Configuration[RSOCL] = 0, RelativeStateOfCharge() and RemainingCapacity() are not held at 99% until charge termination occurs. Fractions of percentages greater than 99% are rounded up to display 100%.

Status	Condition	Action
Charging	GaugingStatus()[REST] = 0 AND BatteryStatus()[DSG] = 0	Charge Algorithm active
Valid Charge Termination	All of the following conditions must occur for two consecutive 40-s periods: Charging (that is, BatteryStatus()[DSG] = 0) AND AverageCurrent() < *Charge Term Taper Current* AND Voltage() + *Charge Term Voltage* ≥ ChargingVoltage() AND *[TAPER_VOLT]* = 0 AND The accumulated change in capacity > 0.25 mAh	ChargingStatus()[VCT] = 1 ChargingStatus()[MCHG] = 1 ChargingVoltage() = Charging Algorithm ChargingCurrent() = Charging Algorithm BatteryStatus()[FC] = 1 and GaugingStatus()[FC] = 1 if *SOC Flag Config A[FCSETVCT]* = 1 BatteryStatus()[TCA] = 1 and GaugingStatus()[TC] = 1 if *SOC Flag Config A[TCSETVCT]* = 1 *Cell 1 Chg Voltage at EoC* = Voltage() *Current at EoC* = Current() Calculate Cell 1 DODEOC Trigger IT simulation

Note:

After valid charge termination, RemainingCapacity() and FullChargeCapacity() will reflect any change in capacity due to any difference in ChargingVoltage() from the previous valid charge termination.

Note:

Setting [TAPER_VOLT] causes Charge Term Charging Voltage to be used in place of ChargingVoltage().

Class	Subclass	Name	Type	Min	Max	Default	Unit	Description
Advanced Charging Algorithms	Termination Config	Charge Term Taper Current	I2	0	32767	100	mA	Valid charge termination taper current qualifier threshold
Advanced Charging Algorithms	Termination Config	Charge Term Voltage	I2	0	32767	100	mV	Valid charge termination delta voltage qualifier, max cell based
Gas Gauging	State	Cell 1 Chg Voltage at EoC	I2	0	32767	4375	mV	Cell 1 Voltage value at end of charge
Gas Gauging	State	Current at EoC	I2	—	32767	100	mA	Current at end of charge