4 Revision History
Changes from Revision * (December 2021) to Revision A (September 2022)
- 向特征 部分中的輸出電壓容差 要點添加了線路、負載和溫度
Go
- 更改了特征 部分中的支持多種陶瓷電容器 要點Go
- 更改了應用 部分Go
- Changed description of OUT pin in Pin Functions: DSBGA tableGo
- Changed typical short-circuit current limit from 300 mA to 325 mA.Go
- Changed typical value of smart enable pulldown resistor from 450 kΩ to 440 kΩ.Go
- Changed Output Voltage Accuracy vs IOUT
and
IQ vs VIN
figures in Typical
Characteristics sectionGo
- Deleted second IGND vs IOUT
figure from
Typical Characteristics sectionGo
- Added discussion regarding sources with limited current drive capability to Smart
Enable (EN) sectionGo
- Changed correct value to nominal value
Go
- Added discussion that input voltage must be high enough to enable the active
discharge to Active Discharge sectionGo
- Added last sentence to Dropout Operation sectionGo
- Changed Input voltage and Output current parameters in Design
Parameters tableGo
- Changed Detailed Design Procedure sectionGo
- Added Device Nomenclature sectionGo