4 Revision History
Changes from Revision E (July 2014) to Revision F (May 2022)
- Updated the Programming-Resistor Values and OC Threshold
tableGo
Changes from Revision D (January 2014) to Revision E (July 2014)
- 添加了 ESD 等級 表、特性說明 部分、器件功能模式、應用和實施 部分、電源相關建議
部分、布局 部分、器件和文檔支持 部分Go
Changes from Revision C (October 2013) to Revision D (January 2014)
- Changed GND_A, GND_B, and GND_C pins description to remove text
"requires close decoupling capacitor to ground"Go
- Changed M2 pin description From: Mode selection pinGo
- Added the THERMAL INFORMATION tableGo
- Added text to the Overcurrent (OC) Protection section - "It is important to note..." Go
- Added text to the Overcurrent (OC) Protection section - "The values in Table 7-2 show typical..." Go
Changes from Revision B (September 2013) to Revision C (October 2013)
- Changed text in the Overcurrent (OC) Protection section From: "cause the device to shutdown immediately." To: "cause the device to shutdown."Go
- Changed Changed text in the Overcurrent (OC) Protection section From: "
RESET_B, and / or must be asserted." To: ", and must be asserted"Go
- Changed paragraph in the DEVICE RESET "A rising-edge transition..."Go
Changes from Revision A (July 2013) to Revision B (September 2013)
- Changed the description of pin M3 From: AGND connection is
recommended To: VREG connection is recommendedGo
Changes from Revision * (May 2010) to Revision A (July 2013)
- Changed text in the OC_ADJ Pin section From: "For accurate control of the oevercurrent protection..." To: "For accurate control of the overcurrent protection..."Go