ZHCSDF3D May 2014 – March 2018 DRV2605L
PRODUCTION DATA.
| PIN | TYPE(1) | DESCRIPTION | |
|---|---|---|---|
| NO. | NAME | ||
| A1 | EN | I | Device enable |
| A2 | REG | O | The REG pin is the 1.8-V regulator output. A 1-µF capacitor is required. |
| A3 | OUT+ | O | Positive haptic driver differential output |
| B1 | IN/TRIG | I | Multi-mode Input. I2C selectable as PWM, analog, or trigger. If not used, this pin should be connected to GND |
| B2 | SDA | I/O | I2C data |
| B3 | GND | P | Supply ground |
| C1 | SCL | I | I2C clock |
| C3 | OUT– | O | Negative haptic-driver differential output |
| C2 | VDD | P | Supply input (2 to 5.2 V). A 1-µF capacitor is required. |
| PIN | TYPE(1) | DESCRIPTION | |
|---|---|---|---|
| NO. | NAME | ||
| 1 | REG | O | The REG pin is the 1.8-V regulator output. A 1-µF capacitor required |
| 2 | SCL | I | I2C clock |
| 3 | SDA | I/O | I2C data |
| 4 | IN/TRIG | I | Multi-mode Input. I2C is selectable as PWM, analog, or trigger. If not used, this pin should be connected to GND |
| 5 | EN | I | Device enable |
| 6 | VDD/NC | P | Optional supply input. This pin should be tied to VDD or left floating. |
| 7 | OUT+ | O | Positive haptic driver differential output |
| 8 | GND | P | Supply ground |
| 9 | OUT– | O | Negative haptic driver differential output |
| 10 | VDD | P | Supply Input (2 V to 5.2 V). A 1-µF capacitor is required. |