ZHCSDI5C March 2015 – October 2022 BQ25895
PRODUCTION DATA
- 1 特性
- 2 應用
- 3 說明
- 4 Revision History
- 5 說明（續）
- 6 Pin Configuration and Functions
- 7 Specifications
-
8 Detailed Description
- 8.1 Functional Block Diagram
- 8.2
Feature Description
- 8.2.1 Device Power-On-Reset (POR)
- 8.2.2 Device Power Up from Battery without Input Source
- 8.2.3 Device Power Up from Input Source
- 8.2.4 Input Current Optimizer (ICO)
- 8.2.5 Boost Mode Operation from Battery
- 8.2.6 Power Path Management
- 8.2.7 Battery Charging Management
- 8.2.8 Battery Monitor
- 8.2.9 Status Outputs (STAT, and INT)
- 8.2.10 BATET (Q4) Control
- 8.2.11 Current Pulse Control Protocol
- 8.2.12 Input Current Limit on ILIM
- 8.2.13 Thermal Regulation and Thermal Shutdown
- 8.2.14 Voltage and Current Monitoring in Buck and Boost Mode
- 8.2.15 Battery Protection
- 8.2.16 Serial Interface
- 8.3 Device Functional Modes
- 8.4 Register Maps
- 9 Application and Implementation
- 10Power Supply Recommendations
- 11Layout
- 12Device and Documentation Support
- 13Mechanical, Packaging, and Orderable Information
封裝選項
機械數據 (封裝 | 引腳)
- RTW|24
散熱焊盤機械數據 (封裝 | 引腳)
- RTW|24
訂購信息
9.2.2.2 Buck Input Capacitor
Input capacitor should have enough ripple current rating to absorb input switching ripple current. The worst case RMS ripple current is half of the charging current when duty cycle is 0.5. If the converter does not operate at 50% duty cycle, then the worst case capacitor RMS current IPMID occurs where the duty cycle is closest to 50% and can be estimated by Equation 7:
Low ESR ceramic capacitor such as X7R or X5R is preferred for input decoupling capacitor and should be placed to the drain of the high side MOSFET and source of the low side MOSFET as close as possible. Voltage rating of the capacitor must be higher than normal input voltage level. 25 V rating or higher capacitor is preferred for up to 14-V input voltage. 8.2-μF capacitance is suggested for typical of 3 A – 5 A charging current.