TPS61007

正在供貨

采用 DGS 封裝且具有可調節輸出的低輸入電壓升壓轉換器

產品詳情

Rating Catalog Topology Boost Switch current limit (typ) (A) 1.1 Vin (max) (V) 3.3 Vin (min) (V) 0.8 Vout (max) (V) 3.3 Vout (min) (V) 1.5 Features Enable, Light-load efficiency, Nonsynchronous, Power good Switching frequency (min) (kHz) 360 Switching frequency (max) (kHz) 840 Operating temperature range (°C) -40 to 125 Iq (typ) (μA) 50 Duty cycle (max) (%) 100 Type Converter
Rating Catalog Topology Boost Switch current limit (typ) (A) 1.1 Vin (max) (V) 3.3 Vin (min) (V) 0.8 Vout (max) (V) 3.3 Vout (min) (V) 1.5 Features Enable, Light-load efficiency, Nonsynchronous, Power good Switching frequency (min) (kHz) 360 Switching frequency (max) (kHz) 840 Operating temperature range (°C) -40 to 125 Iq (typ) (μA) 50 Duty cycle (max) (%) 100 Type Converter
VSSOP (DGS) 10 14.7 mm2 3 x 4.9
  • Start-Up Into a Full Load With Supply Voltages as
    Low as 0.9 V Over Full Temperature Range
  • Minimum 100-mA Output Current From 0.8-V
    Supply Voltage, 250 mA From 1.8 V
  • High Power Conversion Efficiency, up to 90%
  • Power-Save Mode for Improved Efficiency at Low
    Output Currents
  • Device Quiescent Current Less Than 50 μA
  • Added System Security With Integrated Low-
    Battery Comparator
  • Low-EMI Converter (Integrated Antiringing Switch
    Across Inductor)
  • Micro-Size 10-Pin MSOP Package
  • Evaluation Modules Available
    (TPS6100xEVM–156)
  • Start-Up Into a Full Load With Supply Voltages as
    Low as 0.9 V Over Full Temperature Range
  • Minimum 100-mA Output Current From 0.8-V
    Supply Voltage, 250 mA From 1.8 V
  • High Power Conversion Efficiency, up to 90%
  • Power-Save Mode for Improved Efficiency at Low
    Output Currents
  • Device Quiescent Current Less Than 50 μA
  • Added System Security With Integrated Low-
    Battery Comparator
  • Low-EMI Converter (Integrated Antiringing Switch
    Across Inductor)
  • Micro-Size 10-Pin MSOP Package
  • Evaluation Modules Available
    (TPS6100xEVM–156)

The TPS6100x devices are boost converters intended for systems that are typically operated from a single- or dual-cell nickel-cadmium (NiCd), nickel-metal hydride (NiMH), or alkaline battery. The converter output voltage can be adjusted from 1.5 V to a maximum of 3.3 V and provides a minimum output current of 100 mA from a single battery cell and 250 mA from two battery cells. The converter starts up into a full load with a supply voltage of 0.9 V and stays in operation with supply voltages as low as 0.8 V.

The converter is based on a fixed-frequency, current-mode pulse-width-modulation (PWM) controller that goes into power-save mode at low load currents. The current through the switch is limited to a maximum of 1100 mA, depending on the output voltage. The current sense is integrated to further minimize external component count. The converter can be disabled to minimize battery drain when the system is put into standby.

A low-EMI mode is implemented to reduce interference and radiated electromagnetic energy that is caused by the ringing of the inductor when the inductor discharge-current decreases to zero. The device is packaged in the space-saving 10-pin MSOP package.

The TPS6100x devices are boost converters intended for systems that are typically operated from a single- or dual-cell nickel-cadmium (NiCd), nickel-metal hydride (NiMH), or alkaline battery. The converter output voltage can be adjusted from 1.5 V to a maximum of 3.3 V and provides a minimum output current of 100 mA from a single battery cell and 250 mA from two battery cells. The converter starts up into a full load with a supply voltage of 0.9 V and stays in operation with supply voltages as low as 0.8 V.

The converter is based on a fixed-frequency, current-mode pulse-width-modulation (PWM) controller that goes into power-save mode at low load currents. The current through the switch is limited to a maximum of 1100 mA, depending on the output voltage. The current sense is integrated to further minimize external component count. The converter can be disabled to minimize battery drain when the system is put into standby.

A low-EMI mode is implemented to reduce interference and radiated electromagnetic energy that is caused by the ringing of the inductor when the inductor discharge-current decreases to zero. The device is packaged in the space-saving 10-pin MSOP package.
下載

您可能感興趣的相似產品

open-in-new 比較替代產品
功能與比較器件相似
TPS61098 正在供貨 具有集成 LDO 的低輸入電壓、4.3V 輸出電壓、同步升壓轉換器 For applications requiring ultra-low Iq or smaller package.
TPS610981 正在供貨 具有集成 LDO 的低輸入電壓、3.3V 輸出電壓、同步升壓轉換器 For applications requiring ultra-low Iq or smaller package.
TPS610982 正在供貨 具有集成 LDO 的低輸入電壓、4.3V 輸出電壓、同步升壓轉換器 For applications requiring ultra-low Iq or smaller package.

技術文檔

star =有關此產品的 TI 精選熱門文檔
未找到結果。請清除搜索并重試。
查看全部 1
類型 標題 下載最新的英語版本 日期
* 數據表 TPS6100x Single- and Dual-Cell Boost Converter With Start-up Into Full Load 數據表 (Rev. D) PDF | HTML 2015年 8月 31日

訂購和質量

包含信息：
  • RoHS
  • REACH
  • 器件標識
  • 引腳鍍層/焊球材料
  • MSL 等級/回流焊峰值溫度
  • MTBF/時基故障估算
  • 材料成分
  • 鑒定摘要
  • 持續可靠性監測
包含信息：
  • 制造廠地點
  • 封裝廠地點

支持和培訓