LP87524-Q1

正在供貨

具有集成開關的汽車級 10A、單相、四路輸出降壓轉換器

產品詳情

Processor supplier Generic Processor name Generic Product type Radar sensor Regulated outputs (#) 4 Step-down DC/DC converter 4 Step-up DC/DC converter 0 LDO 0 Vin (min) (V) 2.8 Vin (max) (V) 5.5 Vout (min) (V) 0.6 Vout (max) (V) 3.36 Iout (max) (A) 4 Configurability Factory programmable, Software configurable Features Diagnostics, Dynamic voltage scaling, Enable, Enable pin, I2C control, Overcurrent protection, Power good, Power sequencing, Power supply and system monitoring, Spread-Spectrum Clock (SSC) Generation, Thermal shutdown, UVLO fixed Rating Automotive Operating temperature range (°C) -40 to 125 Step-down DC/DC controller 0 Step-up DC/DC controller 0 Iq (typ) (mA) 0.0067 Switching frequency (max) (kHz) 2200 Shutdown current (ISD) (typ) (μA) 1.4 Switching frequency (typ) (kHz) 2000
Processor supplier Generic Processor name Generic Product type Radar sensor Regulated outputs (#) 4 Step-down DC/DC converter 4 Step-up DC/DC converter 0 LDO 0 Vin (min) (V) 2.8 Vin (max) (V) 5.5 Vout (min) (V) 0.6 Vout (max) (V) 3.36 Iout (max) (A) 4 Configurability Factory programmable, Software configurable Features Diagnostics, Dynamic voltage scaling, Enable, Enable pin, I2C control, Overcurrent protection, Power good, Power sequencing, Power supply and system monitoring, Spread-Spectrum Clock (SSC) Generation, Thermal shutdown, UVLO fixed Rating Automotive Operating temperature range (°C) -40 to 125 Step-down DC/DC controller 0 Step-up DC/DC controller 0 Iq (typ) (mA) 0.0067 Switching frequency (max) (kHz) 2200 Shutdown current (ISD) (typ) (μA) 1.4 Switching frequency (typ) (kHz) 2000
VQFN-HR (RNF) 26 18 mm2 4.5 x 4
  • Qualified for Automotive Applications
  • AEC-Q100 Qualified With the Following Results:
    • Device Temperature Grade 1: –40°C to +125°C Ambient Operating Temperature
    • Device HBM ESD Classification Level 2
    • Device CDM ESD Classification Level C4B
  • Input Voltage: 2.8 V to 5.5 V
  • Output Voltage: 0.6 V to 3.36 V
  • Four High-Efficiency Step-Down DC/DC Converter Cores:
    • Maximum Output Current: 10 A
  • Switching Frequency: 2 MHz
  • Spread-Spectrum Mode and Phase Interleaving
  • Configurable General Purpose I/O (GPIOs)
  • I2C-Compatible Interface That Supports Standard (100 kHz), Fast (400 kHz), Fast+ (1 MHz), and High-Speed (3.4 MHz) Modes
  • Interrupt Function With Programmable Masking
  • Programmable Power-Good Signal (PGOOD)
  • Output Short-Circuit and Overload Protection
  • Overtemperature Warning and Protection
  • Overvoltage Protection (OVP) and Undervoltage Lockout (UVLO)
  • Qualified for Automotive Applications
  • AEC-Q100 Qualified With the Following Results:
    • Device Temperature Grade 1: –40°C to +125°C Ambient Operating Temperature
    • Device HBM ESD Classification Level 2
    • Device CDM ESD Classification Level C4B
  • Input Voltage: 2.8 V to 5.5 V
  • Output Voltage: 0.6 V to 3.36 V
  • Four High-Efficiency Step-Down DC/DC Converter Cores:
    • Maximum Output Current: 10 A
  • Switching Frequency: 2 MHz
  • Spread-Spectrum Mode and Phase Interleaving
  • Configurable General Purpose I/O (GPIOs)
  • I2C-Compatible Interface That Supports Standard (100 kHz), Fast (400 kHz), Fast+ (1 MHz), and High-Speed (3.4 MHz) Modes
  • Interrupt Function With Programmable Masking
  • Programmable Power-Good Signal (PGOOD)
  • Output Short-Circuit and Overload Protection
  • Overtemperature Warning and Protection
  • Overvoltage Protection (OVP) and Undervoltage Lockout (UVLO)

The LP8752x-Q1 device is designed to meet the power-management requirements of the latest processors and platforms in various automotive power applications. The device contains four step-down DC/DC converter cores, which are configured as a 4-phase output, 3-phase and 1-phase outputs, 2-phase and 2-phase outputs, one 2-phase and two 1-phase outputs, or four 1-phase outputs. The device is controlled by an I2C-compatible serial interface and by enable signals.

The automatic pulse-width-modulation (PWM) to pulsed-frequency-modulation (PFM) operation (AUTO mode), together with the automatic phase adding and phase shedding, maximizes efficiency over a wide output-current range. The LP8752x-Q1 supports remote differential-voltage sensing for multiphase outputs to compensate IR drop between the regulator output and the point-of-load (POL) improving the accuracy of the output voltage. The switching clock can be forced to PWM mode and also synchronized to an external clock to minimize the disturbances.

The LP8752x-Q1 device supports load-current measurement without the addition of external current-sense resistors. The device also supports programmable start-up and shutdown delays and sequences synchronized to enable signals. The sequences can include GPIO signals to control external regulators, load switches, and processor reset. During start-up and voltage change, the device controls the output slew rate to minimize output-voltage overshoot and in-rush current.

The LP8752x-Q1 device is designed to meet the power-management requirements of the latest processors and platforms in various automotive power applications. The device contains four step-down DC/DC converter cores, which are configured as a 4-phase output, 3-phase and 1-phase outputs, 2-phase and 2-phase outputs, one 2-phase and two 1-phase outputs, or four 1-phase outputs. The device is controlled by an I2C-compatible serial interface and by enable signals.

The automatic pulse-width-modulation (PWM) to pulsed-frequency-modulation (PFM) operation (AUTO mode), together with the automatic phase adding and phase shedding, maximizes efficiency over a wide output-current range. The LP8752x-Q1 supports remote differential-voltage sensing for multiphase outputs to compensate IR drop between the regulator output and the point-of-load (POL) improving the accuracy of the output voltage. The switching clock can be forced to PWM mode and also synchronized to an external clock to minimize the disturbances.

The LP8752x-Q1 device supports load-current measurement without the addition of external current-sense resistors. The device also supports programmable start-up and shutdown delays and sequences synchronized to enable signals. The sequences can include GPIO signals to control external regulators, load switches, and processor reset. During start-up and voltage change, the device controls the output slew rate to minimize output-voltage overshoot and in-rush current.
下載 觀看帶字幕的視頻 視頻
申請了解更多信息

可提供失效模式、影響和診斷分析 (FMEDA)、安全分析報告和安全手冊等功能安全信息。立即申請

您可能感興趣的相似產品

open-in-new 比較替代產品
功能與比較器件相同，且具有相同引腳
LP87523-Q1 正在供貨 具有集成開關的汽車級 10A、兩相 + 單相 + 單相、三路輸出降壓轉換器 Three output phase configuration of LP8752x-Q1 family.
LP87564-Q1 正在供貨 具有集成開關的汽車類多相四通道 4A 降壓轉換器 This product has a higher maximum output current.

技術文檔

star =有關此產品的 TI 精選熱門文檔
未找到結果。請清除搜索并重試。
查看全部 11
類型 標題 下載最新的英語版本 日期
* 數據表 LP8752x-Q1 10-A Buck Converter With Integrated Switches 數據表 PDF | HTML 2018年 3月 15日
用戶指南 LP8752x-Q1 配置指南 (Rev. A) PDF | HTML 英語版 (Rev.A) PDF | HTML 2025年 10月 15日
用戶指南 LP875241S-Q1 Technical Reference Manual PDF | HTML 2024年 6月 25日
用戶指南 LP875241U-Q1 Technical Reference Manual PDF | HTML 2024年 6月 25日
應用手冊 Semidrive X9P/X9U 電源設計 PDF | HTML 英語版 PDF | HTML 2022年 10月 21日
用戶指南 LP875241J-Q1 Technical Reference Manual PDF | HTML 2021年 9月 2日
應用簡報 FlexPower PMIC 設備的優勢 (Rev. B) 英語版 (Rev.B) PDF | HTML 2021年 5月 19日
用戶指南 LP87524x-Q1 Technical Reference Manual (Rev. A) PDF | HTML 2021年 5月 10日
應用手冊 How to Design Flexible Processor Power Systems Using PMICs (Rev. B) 2020年 1月 27日
用戶指南 LP87524T-Q1 Technical Reference Manual (Rev. A) 2019年 10月 30日
應用手冊 Stability Considerations for LP8756x-Q1 and LP8752x-Q1 PDF | HTML 2019年 6月 4日

設計和開發

電源解決方案

了解包含 LP87524-Q1 的解決方案。TI 提供適用于 TI 和非 TI 片上系統 (SoC)、處理器、微控制器、傳感器和現場可編程門陣列 (FPGA) 的電源解決方案。
評估板

LP87524Q1EVM — LP87524-Q1 四路輸出、單相降壓轉換器評估模塊

LP87524Q1EVM 展示了德州儀器 (TI) 的集成電路 LP87524-Q1。LP87524-Q1 是一款高性能多相位降壓轉換器，專為滿足汽車應用中最新應用處理器的電源管理要求而設計。該器件包含 4 個降壓直流/直流轉換器內核，這些內核配置為 4 個獨立的單相降壓轉換器。LP87524-Q1 可以驅動高達 10A 的負載電流，并且集出色的解決方案尺寸和效率于一體。該器件可經由 PC 和提供的 GUI 進行控制。
用戶指南: PDF
TI.com 上無現貨
評估板

LP87564Q1EVM — 具有集成開關的四路輸出單相 4A 降壓轉換器評估模塊

LP87564Q1EVM 展示了德州儀器 (TI) 的集成電路 LP87564-Q1。

LP87564-Q1 是一款高性能多相位降壓轉換器，專為滿足汽車應用中最新應用處理器的電源管理要求而設計。該器件包含 4 個降壓直流/直流轉換器內核，這些內核配置為 4 個單相降壓轉換器。LP87564-Q1 可以驅動高達 4A + 4A + 4A +4A 的負載電流，并且集出色的解決方案尺寸和效率于一體。該器件可經由 PC 和提供的 GUI 進行控制。

可以對此 EVM 進行編程，以匹配 LP87564或 Lp87524系列的任何配置。

用戶指南: PDF
TI.com 上無現貨
仿真模型

LP87524-Q1 PSpice Transient Model (Rev. A)

SNVMB02A.ZIP (360 KB) - PSpice Model
下載
仿真模型

LP8756-Q1 and LP8752-Q1 SIMPLIS Model

SNVMBU8.ZIP (42 KB) - SIMPLIS Model
下載
計算工具

PEET-GUI — PMIC Efficiency Estimator Tool (PEET)

PMIC 效率估算器工具 (PEET GUI) 是一個圖形用戶界面，可根據設計條件輕松評估 PMIC 直流/直流穩壓器的效率。PEET GUI 可用于單獨配置每個直流/直流穩壓器，并以圖形和表格兩種格式提供實時效率和功耗數據。
在云中評估
原理圖

LP8756x and LP8752x Design Checklist

SNVR480.ZIP (116 KB)
下載
封裝 引腳 CAD 符號、封裝和 3D 模型
VQFN-HR (RNF) 26 Ultra Librarian

訂購和質量

包含信息：
  • RoHS
  • REACH
  • 器件標識
  • 引腳鍍層/焊球材料
  • MSL 等級/回流焊峰值溫度
  • MTBF/時基故障估算
  • 材料成分
  • 鑒定摘要
  • 持續可靠性監測
包含信息：
  • 制造廠地點
  • 封裝廠地點

推薦產品可能包含與 TI 此產品相關的參數、評估模塊或參考設計。

支持和培訓

視頻