SPRUJG3 March   2025

1.   1
2.   Description
3.   Features
4.   4
5. 1Evaluation Module Overview
   1. 1.1 Introduction
      1.      Preface: Read This First
         1. 1.1.1.1 Sitara MCU+ Academy
         2. 1.1.1.2 Important Usage Notes
   2. 1.2 Kit Contents
   3. 1.3 Specification
      1. 1.3.1 Component Identification
   4. 1.4 Device Information
      1. 1.4.1 HSEC 180-pin Control Card Docking Station
      2. 1.4.2 Security
6. 2Hardware
   1. 2.1  Power Requirements
      1. 2.1.1 Power Input Using USB Type-C Connector
      2. 2.1.2 Power Status LEDs
      3. 2.1.3 Power Tree
      4. 2.1.4 Power Sequence
      5. 2.1.5 PMIC
   2. 2.2  Functional Block Diagram
   3. 2.3  Reset
   4. 2.4  Clock
   5. 2.5  Boot Mode Selection
   6. 2.6  JTAG Path Selection
   7. 2.7  Header Information
   8. 2.8  GPIO Mapping
   9. 2.9  Push Buttons
   10. 2.10 Interfaces
       1. 2.10.1  Memory Interface
          1. 2.10.1.1 OSPI
          2. 2.10.1.2 Board ID EEPROM
       2. 2.10.2  Ethernet Interface
          1. 2.10.2.1 Control Card Ethernet Routing
          2. 2.10.2.2 On Board Ethernet PHY
          3. 2.10.2.3 LED Indication in RJ45 Connector
          4. 2.10.2.4 Ethernet Add On Board Connector
       3. 2.10.3  I2C
       4. 2.10.4  Industrial Application LEDs
       5. 2.10.5  SPI
       6. 2.10.6  UART
       7. 2.10.7  MCAN
       8. 2.10.8  FSI
       9. 2.10.9  JTAG
       10. 2.10.10 Test Automation Header
       11. 2.10.11 LIN
       12. 2.10.12 MMC
       13. 2.10.13 ADC and DAC
   11. 2.11 HSEC Pinout and Pinmux Mapping
7. 3Hardware Design Files
8. 4Additional Information
   1. 4.1 If You Need Assistance
   2. 4.2 Trademarks
9. 5Related Documentation
   1. 5.1 Supplemental Content
      1.      5.1.A E2 Design Changes
      2.      5.1.B A Design Changes
10. 6References
    1. 6.1 Reference Documents
    2. 6.2 Other TI Components Used in This Design
11. 7Revision History

AM263Px-SIP Control Card Evaluation Module