The following incorrect diagnostic information indicates that something is wrong with the system. If only the following diagnostic information is detected, the system may continue working. These include:

• VBOOST_STATUS calculated voltage is out of expected LED voltage range
• AUTO_PWM_FREQ_SEL is different from system intended settings
• AUTO_LED_STRING_CFG is different from system intended settings
• AUTO_BOOST_FREQ_SEL is different from system intended settings
• MODE_SEL is different from system intended settings

Software could try power cycling the chip once. If the fault is still not recovered, the system may continue working until other faults are detected. However, some problems like brightness degradation, higher EMC, and audible noise might occur if the system keeps working. The engineer should decide whether the system could keep working with such problems based on the specified system requirement.