SLVUCB6 September 2021 TPS22998
This section describes the jumpers and connectors on the EVM as well as how to properly connect, set up, and use the EVM. Table 4-1 describes the input and output connectors and jumpers. Table 4-2 describes the different test points and functionality. Table 4-3 describes the jumper functionality and configurations.
|
Input |
Connector and Test Point |
Label |
Description |
|---|---|---|---|
|
VIN |
J1 |
J1 |
Input banana connector for VIN |
|
TP1 |
VIN |
Input test point for VIN | |
|
TP2 |
VIN SNS |
Sense test point for VIN | |
|
VOUT |
J3 |
J3 |
Output banana connector for VOUT |
|
TP3 |
VOUT Sense |
Sense test point for VOUT | |
|
TP4 |
VOUT |
Output test point for VOUT | |
|
GND |
TP7, TP8, TP9, TP10 |
GND |
Test point for GND |
|
J2, J4 |
J2, J4 |
Banana connector for GND |
|
Pin |
Test Point |
Label |
Description |
|---|---|---|---|
|
ON |
TP6 |
ON |
Enable signal test point |
|
VBIAS |
TP5 |
VBIAS |
Bias Voltage test point |
|
Input |
Jumper |
Label |
Description |
|---|---|---|---|
|
VIN |
JP1 |
ON |
|
|
JP2 |
VBIAS |
BIAS voltage pull up to VIN | |
|
CT |
JP3 |
CT |
|