SLVUC71 May 2021 TPS22992
This section describes the jumpers and connectors on the EVM as well as how to properly connect, set up and use the EVM. Table 2 describes the input and output connectors and jumpers. Table 3 describes the different test points and functionality. Table 4 describes the jumper functionality and configurations.
| Input | Connector and Test Point | Label | Description |
|---|---|---|---|
| VIN | J1 | J1 | Input banana connector for VIN |
| TP1 | VIN | Input test point for VIN | |
| TP2 | VIN Sense |
Sense test point for VIN |
|
| VOUT | J3 |
J3 |
Output banana connector for VOUT |
| TP7 | VOUT |
Output test point for VOUT |
|
| TP6 | VOUT Sense |
Sense test point for VOUT |
|
| GND | TP8, TP9, TP10, TP11 |
GND | Test point for GND |
|
J2, J4 |
J2, J4 |
Banana connector for GND |
|
Pin |
Test Point | Label | Description |
|---|---|---|---|
|
ON |
TP4 | ON | Enable signal test point |
|
VBIAS |
TP3 |
VBIAS |
Bias voltage test point |
|
PG |
TP5 |
PG |
Power good signal test point |
| Input | Jumper | Label | Description |
|---|---|---|---|
| VIN | JP2 |
VBIAS |
BIAS voltage pull up to VIN |
| JP1 | ON | ON-pin enable signal
|
|
|
VOUT |
JP3, JP4, JP5 |
JP3, JP4, JP5 |
Quick output discharge setting
|