SLVUBZ0A November 2020 – December 2020 TPS2116
This section provides an overview of the TPS2116 evaluation board connector and jumpers. Table 3-1 describes the input and output connectors and jumpers. Table 3-2 describes the different test points and functinality. Table 3-3 describes the jumper functionality and configurations.
| Input | Connector and Test Point | Label | Description |
|---|---|---|---|
| VIN1 | J1 | VIN1+ | VIN1 Input connector |
| TP1 | VIN1 | VIN1 input test point | |
| TP2 | VIN1 SENSE | VIN1 SENSE test point | |
| VIN2 | J3 | VIN2+ | VIN2 Input connector |
| TP3 | VIN2 | VIN2 input test point | |
| TP4 | VIN2 SENSE | VIN2 SENSE test point | |
| VOUT | J4 | VOUT+ | VOUT output connector |
| TP5 | VOUT SENSE | VOUT SENSE test point | |
| TP6 | VOUT | VOUT output test point | |
| GND | J2 | GND | GND connector for inputs |
| J5 | GND | GND connector for output | |
| TP10, TP11, TP12, TP13 | GND | Test point for GND |
| Input | Test point | Label | Description |
|---|---|---|---|
| VOUT | TP7 | ST | Output status pin test point |
| VIN1 | TP8 | PR1 | Priority test point for VIN1 |
| TP9 | MODE | Mode pin test point |
| Input | Jumper | Label | Description |
|---|---|---|---|
| VIN1 | JP1, JP2, JP3 | 1.8 V, 3.3 V, 5 V | Configures voltage divider for priority operation |
| JP4 | JP4 | Configures mode of operation
| |
| VOUT | JP5 | JP5 | Sets hysteresis
|
| JP6 | JP6 | 1-μF outputcapacitor | |
| JP7 | JP7 | 10-μF outputcapacitor | |
| JP8 | JP8 | 100-μF outputcapacitor | |
| JP9 | JP9 | 10-Ω output resistor |