2 EVM Setup and Requirements

Use the following equipment to evaluate the performance of the TLIN1039-Q1 and TLIN1021A-Q1 devices:

• Power supply capable of supplying the desired supply voltage. Typical LIN applications use 12 V or
  24 V, but the TLIN1039-Q1 and TLIN1021A-Q1 operate with any supply voltage from 4.5 V to 36 V. Connect this voltage across the VBAT and GND pins of either the J2, J3, or J5 connectors.
• Power supply capable of supplying the desired IO pin voltage from 2 V to 5.5 V. Connect this voltage across the VCC and GND pins of the J6 connector.
• If the LIN bus interface or the INH pin (TLIN1021A-Q1) is to be observed on an oscilloscope, use probes capable of tolerating voltages as large as VBAT.
• The logic interface pins (TXD: TP6, RXD: TP7, and EN: TP5) may interface to a microcontroller, pattern generator, or logic analyzer with logic levels matching the VCC voltage.