SLUUC71 May 2021 TCAN1162-Q1 , TCAN11623-Q1 , TCAN11625-Q1
Table 3-1 lists the jumper configurations and test points on the EVM.
| Designator | Description | Function |
|---|---|---|
| J6 | 2x1 TH header | J6 connects D1 to the TS pin. This enables the indicator LED to illuminate when the TS pin is low. |
| J8 | 2x1 TH header | J8 allows the connection of LDO3 (TCAN11623-Q1) or LDO5 (TCAN11625-Q1) to VIO, supplying the IO voltage directly from the integrated LDO on these devices. |
| J9 | 2x1 TH header | J9 connects nSLP to VIO through a pull-up resistance. Shorting this jumper with a shunt keeps nSLP high indefinitely, leaving the device out of sleep mode. |
| J12 | 2x1 TH header | J12 connects one 120-Ω resistance to the CAN bus. |
| J14 | 2x1 TH header | J14 connects INH to GND through a pull-down resistor. |
| J15 | 2x1 TH header | J15 connects one 120-Ω resistor to the CAN bus. |
| J16 | 2x1 TH header | J16 shorts VBAT and VSUP together, bypassing the reverse-protection diode. |
| TP1 | Red multipurpose test point | TP1 allows the user to probe the VIO pin of the TCAN1162-Q1 device. |
| TP2 | Red multipurpose test point | TP2 allows the user to probe the VSUP pin of the TCAN1162-Q1 device. |
| TP3, TP4 | Black multipurpose test point | TP3 and TP4 are connected to GND. |
| TP5 | Green multipurpose test point | TP5 allows the user to probe the TS pin of the TCAN1162-Q1 device. |
| TP6 | Green multipurpose test point | TP6 allows the user to probe the nSLP pin of the TCAN1162-Q1 device. |
| TP7 | Green multipurpose test point | TP7 allows the user to probe the RXD pin of the TCAN1162-Q1 device. |
| TP8 | Green multipurpose test point | TP8 allows the user to probe the TXD pin of the TCAN1162-Q1 device. |
| TP9 | Yellow multipurpose test point | TP9 allows the user to probe the WAKE pin of the TCAN1162-Q1 device. |
| TP10 | Yellow multipurpose test point | TP10 allows the user to probe the INH pin of the TCAN1162-Q1 device. |
| TP11 | Green multipurpose test point | TP11 allows the user to probe the nRST pin of the TCAN1162-Q1 device. |
| TP12 | Red multipurpose test point | TP12 allows the user to probe the LDO5 pin if the TCAN11625-Q1 device is populated on the PCB. |
| TP13 | Red multipurpose test point | TP13 allows the user to probe the LDO3 pin oi the TCAN11623-Q1 device is populated on the PCB. |