SLUUBA2B March 2015 – November 2015 BQ25890 , BQ25892 , BQ25895 , BQ25895M , BQ25896
2.3.3 Boost Mode Verification
- Turn off and disconnect PS#1
- If the constant voltage load connected from BAT+ to GND is not a four-quadrant supply (sources current), remove the load and use the power source disconnected in step one, set to 3.7-V and 2-A current limit and connect between BAT+ and GND
- Check the OTG configurations option in the GUI
- Apply 10 Ω (5 W or greater) across J2 (PMID(+) to GND(–))
- Measure: V: (TP2 (PMID) and TP6 (GND)) = 5.0 V ±200 mV