ZHCSEG8F December 2015 – December 2023 TUSB542
PRODUCTION DATA
- 1
- 1 特性
- 2 應用
- 3 說明
- 4 Pin Configuration and Functions
-
5 Specifications
- 5.1 Absolute Maximum Ratings
- 5.2 ESD Ratings
- 5.3 Recommended Operating Conditions
- 5.4 Thermal Information
- 5.5 Electrical Characteristics, Power Supply Currents
- 5.6 Electrical Characteristics, DC
- 5.7 Electrical Characteristics, Dynamic
- 5.8 Electrical Characteristics, AC
- 5.9 Timing Requirements
- 5.10 Switching Characteristics
- 5.11 Typical Characteristics
- 6 Detailed Description
- 7 Application and Implementation
- 8 Device and Documentation Support
- 9 Revision History
- 10Mechanical, Packaging, and Orderable Information
封裝選項
機械數據 (封裝 | 引腳)
- RWQ|18
散熱焊盤機械數據 (封裝 | 引腳)
訂購信息
7.2.2 Detailed Design Procedure
Figure 7-2 shows an example implementation of an USB Type-C DRP port using TUSB542. Texas Instruments TUSB322 is shown here as channel configuration (CC) controller. Note: connections for CNFG pins of TUSB542 is an example only. The connection of the CNFG pins is application dependent; refer to Table 6-2, where the user can find the available settings.
It is recommended to run an overall system signal integrity analysis, to estimate the channel loss and configure the re-driver. It is also recommended to have pull-up and pull-down option on the configuration pins for debug and testing purposes.
The signal integrity analysis must determine the following:
- Equalization (EQ) setting
- De-emphasis (DE) setting
- Output swing amplitude (OS) setting
The equalization must be set based on the insertion loss in the pre-channel (channel before the TUSB542 device). The input voltage to the device is able to have a large range because of the receiver sensitivity and the available EQ settings.
The de-emphasis setting must be set based on the length and characteristics of the post channel (channel after the TUSB542 device).
Figure 7-2 USB-C DRP Implementation Using TUSB542 and TUSB322/TUSB321