5 Revision History
Changes from D Revision (January 2014) to E Revision
-
Added Pin Configuration and Functions section, ESD Ratings table, Feature Description section, Device Functional Modes, Application and Implementation section, Power Supply Recommendations section, Layout section, Device and Documentation Support section, and Mechanical, Packaging, and Orderable Information section Go
Changes from C Revision (October 2012) to D Revision
-
Changed the FUNCTIONAL BLOCK DIAGRAM to include the SYNC pinGo
-
Changed the Revision History listGo
Changes from B Revision (October 2012) to C Revision
-
Changed ESD - HBM From: 4 kV To: 2 kVGo
-
Deleted ESD - MMGo
-
Changed ESD - CDM From: 1.5 kV To: 500 VGo
-
Changed the CONSTANT-FREQUENCY MODE OF OPERATION (SYNC = HIGH) sectionGo
Changes from A Revision (February 2009) to B Revision
-
Changed Description text From: 2-cell Li-ion battery To: 2 to 4-cell Li-ion battery..Go
-
Added text to the Terminal Functions EN pin description - Do not leave floating.Go
-
Added ESD information to the ABSOLUTE MAXIMUM RATINGS tableGo
-
Changed From: Dissipation Ratings table To: Thermal Information tableGo
-
Added TPS62113 to the OUTPUT section of the Electrical CharacteristicsGo
-
Changed Note A of the Functional Block Diagram.Go
-
Changed the ENABLE sectionGo
-
Changed the LOW-BATTERY DETECTOR (Standard Version) sectionGo
-
Deleted the PwPD pin from Figure 4, Go
-
Changed the ENABLE/Low-Battery Detector (Enhanced Version) TPS62113 Only sectionGo
-
Changed the POWER-GOOD COMPARATOR sectionGo
-
Added the THERMAL SHUTDOWN sectionGo
-
Changed the SOFT START sectionGo
-
Deleted "by pulling the SYNC pin LOW." - CONSTANT-FREQUENCY MODE OF OPERATION (SYNC = HIGH)Go
-
Changed Go
-
Changed PwPD to ETPad in Figure 6 to Figure 21Go
-
Changed the INPUT-CAPACITOR SELECTION sectionGo
-
Changed Figure 19 and Figure 20Go
-
Added section: Layout ConsiderationGo