ZHCSJJ7H april 2019 – june 2023 TLV9061-Q1 , TLV9062-Q1 , TLV9064-Q1
PRODMIX
| 參數 | 測試條件 | 最小值 | 典型值 | 最大值 | 單位 | ||
|---|---|---|---|---|---|---|---|
| 失調電壓 | |||||||
| VOS | 輸入失調電壓 | VS = 5V | ±0.3 | ±1.85 | mV | ||
| VS = 5V，TA = –40°C 至 125°C | ±2 | ||||||
| dVOS/dT | 漂移 | VS = 5V，TA = –40°C 至 125°C | ±0.53 | μV/°C | |||
| PSRR | 電源抑制比 | VS = 1.8V – 5.5V，VCM = (V–) | ±7 | ±80 | μV/V | ||
| 通道分離，直流 | 直流時 | 100 | dB | ||||
| 輸入電壓范圍 | |||||||
| VCM | 共模電壓范圍 | VS = 1.8V 至 5.5V | (V–) – 0.1 | (V+)+0.1 | V | ||
| CMRR | 共模抑制比 | VS = 5.5V，(V–) – 0.1V < VCM < (V+) – 1.4V TA = –40°C 至 125°C | 80 | 103 | dB | ||
| VS = 5.5V，VCM = –0.1V 至 5.6V TA = –40°C 至 125°C | 57 | 75 | |||||
| VS = 1.8V，(V–) – 0.1V < VCM < (V+) – 1.4V， TA = –40°C 至 125°C | 88 | ||||||
| VS = 1.8V，VCM = –0.1V 至 1.9V TA = –40°C 至 125°C | 70 | ||||||
| 輸入偏置電流 | |||||||
| IB | 輸入偏置電流 | ±5 | pA | ||||
| IOS | 輸入失調電流 | ±5 | pA | ||||
| 噪聲 | |||||||
| En | 輸入電壓噪聲（峰峰值） | VS = 5V，f = 0.1Hz 至 10Hz | 4.77 | μVPP | |||
| en | 輸入電壓噪聲密度 | VS = 5V，f = 10kHz | 10 | nV/√Hz | |||
| VS = 5V，f = 1kHz | 16 | ||||||
| in | 輸入電流噪聲密度 | f = 1kHz | 23 | fA/√Hz | |||
| 輸入電容 | |||||||
| CID | 差分 | 2 | pF | ||||
| CIC | 共模 | 4 | pF | ||||
| 開環增益 | |||||||
| AOL | 開環電壓增益 | VS = 1.8V，(V–) + 0.04V < VO < (V+) – 0.04V， RL = 10kΩ | 100 | dB | |||
| VS = 5.5V，(V–) + 0.05V < VO < (V+) – 0.05V， RL = 10kΩ | 104 | 130 | |||||
| VS = 1.8V，(V–) + 0.06V < VO < (V+) – 0.06V， RL = 2kΩ | 100 | ||||||
| VS = 5.5V，(V–) + 0.15V < VO < (V+) – 0.15V， RL = 2kΩ | 130 | ||||||
| 頻率響應 | |||||||
| GBP | 增益帶寬積 | VS = 5V，G = +1 | 10 | MHz | |||
| φm | 相位裕度 | VS = 5V，G = +1 | 55 | ° | |||
| SR | 壓擺率 | VS = 5V，G = +1 | 6.5 | V/μs | |||
| tS | 趨穩時間 | 精度達到 0.1%，VS = 5V，2V 階躍，G = +1，CL = 100pF | 0.5 | μs | |||
| 精度達到 0.01%，VS = 5V，2V 階躍， G = +1，CL = 100pF | 1 | ||||||
| tOR | 過載恢復時間 | VS = 5V，VIN × 增益 > VS | 0.2 | μs | |||
| THD + N | 總諧波失真 + 噪聲(1) | VS = 5.5V，VCM = 2.5V，VO = 1VRMS，G = +1， f = 1kHz | 0.0008% | ||||
| 輸出 | |||||||
| VO | 相對于電源軌的電壓輸出擺幅 | VS = 5.5V，RL = 10kΩ | 20 | mV | |||
| VS=5.5V，RL=2kΩ | 60 | ||||||
| ISC | 短路電流 | VS = 5V | ±50 | mA | |||
| ZO | 開環輸出阻抗 | VS = 5V，f = 10MHz | 100 | Ω | |||
| 電源 | |||||||
| IQ | 每個放大器的靜態電流 | VS = 5.5V，IO = 0mA | 538 | 750 | μA | ||
| VS = 5.5V，IO = 0mA，TA = –40°C 至 125°C | 800 | ||||||
| 關斷(2) | |||||||
| IQSD | 每個放大器的靜態電流 | VS = 1.8V 至 5.5V，所有放大器都被禁用，SHDN = 低電平 | 0.5 | 1.5 | μA | ||
| ZSHDN | 關斷時的輸出阻抗 | VS = 1.8V 至 5.5V，放大器為禁用狀態 | 10 || 8 | GΩ || pF | |||
| VSHDN_THR_HI | 高電平電壓關斷閾值（放大器為啟用狀態） | VS = 1.8V 至 5.5V | (V–) + 0.9 | (V–) + 1.1 | V | ||
| VSDHN_THR_LO | 低電平電壓關斷閾值（放大器為禁用狀態） | VS = 1.8V 至 5.5V | (V–) + 0.2 | (V–) + 0.7 | V | ||
| tON | 放大器啟用時間（關斷）(3) | VS = 1.8V 至 5.5V，完全關斷；G = 1，VOUT = 0.9 × VS/2，RL 連接到 V– | 10 | μs | |||
| tOFF | 放大器禁用時間(3) | VS = 1.8V 至 5.5V，G = 1，VOUT = 0.1 × VS/2，RL 連接到 V– | 0.6 | μs | |||
| SHDN 引腳輸入偏置電流（每個引腳） | VS = 1.8V 至 5.5V，V+ ≥ SHDN ≥ (V+) - 0.8V | 130 | pA | ||||
| VS = 1.8V 至 5.5V，(V–) ≤ SHDN ≤ (V–) + 0.8V | 40 | ||||||