ZHCSRL5H December 1982 – April 2021 SN54HC04 , SN74HC04
PRODUCTION DATA
請參考 PDF 數據表獲取器件具體的封裝圖。
Unused inputs must be terminated to either VCC or ground. These can be directly terminated if the input is completely unused, or they can be connected with a pull-up or pull-down resistor if the input is to be used sometimes, but not always. A pull-up resistor is used for a default state of HIGH, and a pull-down resistor is used for a default state of LOW. The resistor size is limited by drive current of the controller, leakage current into the SN74HC04, as specified in the Electrical Characteristics - 74, and the desired input transition rate. A 10-kΩ resistor value is often used due to these factors.
The SN74HC04 has standard CMOS inputs, so input signal edge rates cannot be slow. Slow input edge rates can cause oscillations and damaging shoot-through current. The recommended rates are defined in the Recommended Operating Conditions.
Refer to GUID-35452279-FB16-457B-9F0E-D2607C61D517.html#GUID-35452279-FB16-457B-9F0E-D2607C61D517 for additional information regarding the inputs for this device.