ZHCSIT6AB June 1976 – October 2024 LM158 , LM158A , LM258 , LM258A , LM2904 , LM2904B , LM2904BA , LM2904V , LM358 , LM358A , LM358B , LM358BA
PRODUCTION DATA
請參考 PDF 數據表獲取器件具體的封裝圖。
| 參數 | 測試條件 | 最小值 | 典型值 | 最大值 | 單位 | |||
|---|---|---|---|---|---|---|---|---|
| 失調電壓 | ||||||||
| VOS | 輸入失調電壓 | LM2904B | ±0.3 | ±3.0 | mV | |||
| TA = -40°C 至 +125°C | ±4 | mV | ||||||
| LM2904BA | ±2.0 | mV | ||||||
| TA = -40°C 至 +125°C | ±3.0 | mV | ||||||
| dVOS/dT | 輸入失調電壓溫漂 | TA = -40°C 至 +125°C(1) | ±3.5 | 12 | μV/°C | |||
| PSRR | 電源抑制比 | ±2 | 15 | μV/V | ||||
| 通道分離，直流 | f = 1kHz 至 20kHz | ±1 | μV/V | |||||
| 輸入電壓范圍 | ||||||||
| VCM | 共模電壓范圍 | VS = 3V 至 36V | (V–) | (V+) – 1.5 | V | |||
| VS = 5V 至 36V | TA = -40°C 至 +125°C | (V–) | (V+) – 2 | V | ||||
| CMRR | 共模抑制比 | (V–) ≤ VCM ≤ (V+) – 1.5V | VS = 3V 至 36V | 20 | 100 | μV/V | ||
| (V–) ≤ VCM ≤ (V+) – 2.0V | VS = 5V 至 36V | TA = -40°C 至 +125°C | 25 | 316 | ||||
| 輸入偏置電流 | ||||||||
| IB | 輸入偏置電流 | -10 | -35 | nA | ||||
| TA = -40°C 至 +125°C(1) | -50 | nA | ||||||
| IOS | 輸入失調電流 | 0.5 | 4 | nA | ||||
| TA = -40°C 至 +125°C(1) | 5 | nA | ||||||
| dIOS/dT | 輸入失調電流漂移 | TA = -40°C 至 +125°C | 10 | pA/℃ | ||||
| 噪聲 | ||||||||
| En | 輸入電壓噪聲 | f = 0.1Hz 至 10Hz | 3 | μVPP | ||||
| en | 輸入電壓噪聲密度 | f = 1kHz | 40 | nV/√/Hz | ||||
| 輸入阻抗 | ||||||||
| ZID | 差分 | 10 || 0.1 | MΩ || pF | |||||
| ZIC | 共模 | 4 || 1.5 | GΩ || pF | |||||
| 開環增益 | ||||||||
| AOL | 開環電壓增益 | VS = 15V；VO = 1V 至 11V；RL ≥ 10k?，連接至 (V-) | 70 | 140 | V/mV | |||
| TA = -40°C 至 +125°C | 35 | V/mV | ||||||
| 頻率響應 | ||||||||
| GBW | 增益帶寬積 | 1.2 | MHz | |||||
| SR | 壓擺率 | G = +1 | 0.5 | V/μs | ||||
| Θm | 相位裕度 | G = + 1，RL = 10kΩ，CL = 20pF | 56 | ° | ||||
| tOR | 過載恢復時間 | VIN × 增益 > VS | 10 | μs | ||||
| ts | 穩定時間 | 精度達到 0.1%，VS = 5V，2V 階躍，G = +1，CL = 100pF | 4 | μs | ||||
| THD+N | 總諧波失真 + 噪聲 | G = +1，f = 1kHz，VO = 3.53VRMS，VS = 36V，RL = 100k，IOUT ≤ ±50μA，BW = 80kHz | 0.001 | % | ||||
| 輸出 | ||||||||
| VO | 相對于電源軌的電壓輸出擺幅 | 正電源軌 (V+) | IOUT = 50μA | 1.35 | 1.42 | V | ||
| IOUT = 1mA | 1.4 | 1.48 | V | |||||
| IOUT = 5mA(1) | 1.5 | 1.61 | V | |||||
| 負電源軌 (V-) | IOUT = 50μA | 100 | 150 | mV | ||||
| IOUT = 1mA | 0.75 | 1 | V | |||||
| VS = 5V，RL ≤ 10k? 連接到 (V–) | TA = -40°C 至 +125°C | 5 | 20 | mV | ||||
| IO | 輸出電流 | VS = 15V；VO = V-；VID = 1V | 拉電流(1) | -20 | -30 | mA | ||
| TA = -40°C 至 +125°C | -10 | |||||||
| VS = 15V；VO = V+；VID = 1V | 灌電流(1) | 10 | 20 | |||||
| TA = -40°C 至 +125°C | 5 | |||||||
| VID = -1V；VO = (V-) + 200mV | 60 | 100 | μA | |||||
| ISC | 短路電流 | VS = 20V，(V+) = 10V，(V-) = -10V，VO = 0V | ±40 | ±60 | mA | |||
| CLOAD | 容性負載驅動 | 100 | pF | |||||
| RO | 開環輸出電阻 | f = 1MHz，IO = 0A | 300 | Ω | ||||
| 電源 | ||||||||
| IQ | 每個放大器的靜態電流 | VS = 5V，IO = 0A | TA = -40°C 至 +125°C | 300 | 460 | μA | ||
| IQ | 每個放大器的靜態電流 | VS = 36V，IO = 0A | 800 | μA | ||||