ZHCSQN4AE August 1975 – September 2025 LM124 , LM124A , LM224 , LM224A , LM224K , LM224KA , LM2902 , LM2902B , LM2902BA , LM2902K , LM2902KAV , LM2902KV , LM324 , LM324A , LM324B , LM324BA , LM324K , LM324KA
PRODUCTION DATA
| 參數 | 測試條件 | 最小值 | 典型值 | 最大值 | 單位 | |||
|---|---|---|---|---|---|---|---|---|
| 失調電壓 | ||||||||
| VOS | 輸入偏移電壓 | LM324B | ±0.6 | ±3.0 | mV | |||
| TA = -40°C 至 +85°C | ±4.0 | |||||||
| LM324BA | ±0.3 | ±2 | ||||||
| TA = -40°C 至 +85°C | 2.5 | |||||||
| dVOS/dT | 輸入失調電壓漂移 | RS = 0? | TA = -40°C 至 +85°C | ±7 | μV/°C | |||
| PSRR | 輸入失調電壓與電源間的關系 | 65 | 100 | dB | ||||
| 通道隔離 | f = 1kHz 至 20kHz | 120 | dB | |||||
| 輸入電壓范圍 | ||||||||
| VCM | 共模電壓 | VS = 3V 至 36V | V– | (V+) – 1.5 | V | |||
| VS = 5V 至 36V，TA = -40°C 至 +85°C | V– | (V+) – 2 | ||||||
| CMRR | 共模抑制比 | VS = 3V 至 36V，(V–) ≤ VCM ≤ (V+) – 1.5V | 70 | 80 | dB | |||
| VS = 5V 至 36V，(V–) ≤ VCM ≤ (V+) – 2V，TA = –40°C 至 +85°C | 65 | 80 | ||||||
| 輸入偏置電流 | ||||||||
| IB | 輸入偏置電流 | -10 | -35 | nA | ||||
| TA = -40°C 至 +85°C | -60 | |||||||
| dIOS/dT | 輸入失調電流漂移 | TA = -40°C 至 +85°C | 10 | pA/°C | ||||
| IOS | 輸入失調電流 | ±0.5 | ±4 | nA | ||||
| TA = -40°C 至 +85°C | ±5 | |||||||
| dIOS/dT | 輸入失調電流漂移 | TA = -40°C 至 +85°C | 10 | pA/°C | ||||
| 噪聲 | ||||||||
| EN | 輸入電壓噪聲 | f = 0.1Hz 至 10Hz | 3 | μVPP | ||||
| eN | 輸入電壓噪聲密度 | RS = 100?，VI = 0V，f = 1kHz（有關測試電路，請參閱圖 6-2） | 35 | nV/√Hz | ||||
| 輸入電容 | ||||||||
| ZID | 差分 | 10 || 0.1 | MΩ || pF | |||||
| ZICM | 共模 | 4 || 1.5 | GΩ || pF | |||||
| 開環增益 | ||||||||
| AOL | 開環電壓增益 | VS = 15V，VO = 1V 至 11V，RL ≥ 10k?， 連接到 (V-) |
50 | 100 | V/mV | |||
| TA = -40°C 至 +85°C | 25 | |||||||
| 頻率響應 | ||||||||
| GBW | 增益帶寬積 | RL = 1M?，CL = 20pF（有關測試電路，請參閱圖 6-1） | 1.2 | MHz | ||||
| SR | 壓擺率 | RL = 1M?，CL = 30pF，VI = ±10V（有關測試電路，請參閱圖 6-1） | 0.5 | V/μs | ||||
| Θm | 相位裕度 | G = +1，RL = 10kΩ，CL = 20pF | 56 | ° | ||||
| tS | 趨穩時間 | 精度達到 0.1%，VS = 5V，2V 階躍，G = +1，CL = 100pF | 4 | μs | ||||
| 過載恢復時間 | VIN × 增益 > VS | 10 | μs | |||||
| THD+N | 總諧波失真 + 噪聲 | G = +1，f = 1kHz，VO = 3.53VRMS，VS = 36V，RL = 100kΩ，IOUT ≤ 50μA，BW = 80kHz | 0.001% | |||||
| 輸出 | ||||||||
| VO | 相對于電源軌的電壓輸出擺幅 | 正電源軌 (V+) | IOUT = -50μA | 1.35 | 1.5 | V | ||
| IOUT = -1mA | 1.4 | 1.6 | ||||||
| IOUT = -5mA | 1.5 | 1.75 | ||||||
| 負電源軌 (V–) | IOUT = 50μA | 100 | 150 | mV | ||||
| IOUT = 1mA | 0.75 | 1 | V | |||||
| VS = 5V，RL ≤ 10k?，連接至 (V–)， TA = –40°C 至 +85°C |
5 | 20 | mV | |||||
| IO | 輸出電流 | 拉電流，VS = 15V，VO = V–，VID = 1V | -20(1) | -30 | mA | |||
| TA = -40°C 至 +85°C | -10(1) | |||||||
| 灌電流，VS = 15V，VO = V+，VID = –1V | 10(1) | 20 | ||||||
| TA = -40°C 至 +85°C | 5(1) | |||||||
| VID = –1V，VO = (V–) + 200mV | 50 | 85 | μA | |||||
| ISC | 短路電流 | VS = 20V，(V+) = 10V，(V–) = –10V，VO = 0V | ±40 | ±60 | mA | |||
| CLOAD | 容性負載驅動 | 100 | pF | |||||
| RO | 開環輸出阻抗 | f = 1MHz，IO = 0A | 300 | ? | ||||
| 電源 | ||||||||
| IQ | 每個放大器的靜態電流 | VS = 5V，IO = 0A，TA = –40°C 至 +85°C | 240 | 300 | μA | |||
| VS = 36V，IO = 0A，TA = –40°C 至 +85°C | 350 | 750 | ||||||