ZHCSRJ0D September 1997 – April 2021 CD54HC32 , CD74HC32
PRODUCTION DATA
請參考 PDF 數據表獲取器件具體的封裝圖。
Unused inputs must be terminated to either VCC or ground. These can be directly terminated if the input is completely unused, or they can be connected with a pull-up or pull-down resistor if the input is to be used sometimes, but not always. A pull-up resistor is used for a default state of HIGH, and a pull-down resistor is used for a default state of LOW. The resistor size is limited by drive current of the controller, leakage current into the CD74HC32, as specified in the Electrical Characteristics, and the desired input transition rate. A 10-kΩ resistor value is often used due to these factors.
The CD74HC32 has standard CMOS inputs, so input signal edge rates cannot be slow. Slow input edge rates can cause oscillations and damaging shoot-through current. The recommended rates are defined in the Recommended Operating Conditions.
Refer to GUID-3FE704FF-4F73-41D2-8493-3F72D768C49E.html#GUID-3FE704FF-4F73-41D2-8493-3F72D768C49E for additional information regarding the inputs for this device.