SNVU817 November 2021 LMR38020-Q1
2.1 Quick Start Procedure
- Connect the voltage supply between VIN and GND connectors using short wires.
- Connect the load of the converter between VOUT and GND connectors using short wires.
- Set the supply voltage (VIN) at an appropriate level between 6 V to 80 V. Set the current limit of the supply to an appropriate level as well.
- Turn on the power supply. The EVM powers up and provides VOUT = 5 V.
- Monitor the output voltage while increasing the load current to 2-A maximum.
See Figure 2-1 for the location of the connectors.
Figure 2-1 LMR38020QEVM Top ViewWARNING:
|
||
|
Hot surface! Contact may cause burns. Do not touch! |
||