SLUSFZ6 September 2025 UCC218915-Q1
ADVANCE INFORMATION
- 1
- 1 Features
- 2 Applications
- 3 Description
- 4 Pin Configuration and Functions
- 5 Specifications
-
6 Detailed Description
- 6.1 Overview
- 6.2 Functional Block Diagram
- 6.3
Feature Description
- 6.3.1 Power Supplies
- 6.3.2 VCC and VDD Undervoltage Lockout (UVLO)
- 6.3.3 Input Filters for IN+, IN- and RST/EN
- 6.3.4 Pre-Driver Outputs
- 6.3.5 External Active Miller Clamp
- 6.3.6 Desaturation (DESAT) Protection
- 6.3.7 Soft Shutdown
- 6.3.8 Fault (FLT), Reset and Enable (RST/EN)
- 6.3.9 Active Short Circuit (ASC) Support and Feedback (ASC_FB)
- 6.3.10 Overtemperature Protection
- 6.4 Device Functional Modes
- 7 Applications and Implementation
- 8 Device and Documentation Support
- 9 Revision History
- 10Mechanical, Packaging, and Orderable Information
請參考 PDF 數據表獲取器件具體的封裝圖。
機械數據 (封裝 | 引腳)
- DFP|28
散熱焊盤機械數據 (封裝 | 引腳)
7.2.2.3 FLT, RDY, and RST/EN Pin Circuitry
Both FLT and RDY pin are open-drain output. The RST/EN pin has 100kΩ internal pulldown resistor, so the driver is in OFF status if the RST/EN pin is not pulled up externally. A 5kΩ resistor can be used as pullup resistor for the FLT and RDY pins.
To improve the noise immunity due to the parasitic coupling and common mode noise, low pass filters can be added between the FLT, RDY, and RST/EN pins and the microcontroller. A filter capacitor between 100pF to 300pF can be added.
Figure 7-4 FLT, RDY
and RST/EN Pins Circuitry